Accessing The Management Processor Via A Web Browser; The Ls Command Screen - HP rp7440 Installation Manual

Installation guide, fourth edition - hp integrity rx7640 and hp 9000 rp7440 servers

Hide thumbs Also See for rp7440:

Table of Contents

10. A screen similar to the following is displayed, allowing verification of the settings:

Figure 2-32 The ls Command Screen

11. To return to the MP main menu, enter ma.

12. To exit the MP, enter x at the MP main menu.

Accessing the Management Processor via a Web Browser

Web browser access is an embedded feature of the MP/SCSI card. The Web browser enables

access to the server through the LAN port on the core I/O card. MP configuration must be done

from an ASCII console connected to the Local RS232 port..

NOTE:

The MP/SCSI card has a separate LAN port from the system LAN port. It requires a

separate LAN drop, IP address, and networking information from that of the port used by HP-UX.

Before starting this procedure, the following information is required:

•

IP address for the MP LAN

•

Subnet mask

•

Gateway address

•

Host name (this is used when messages are logged or printed)

To configure the LAN port for a Web browser, perform the following steps:

Connect to the MP using a serial connection.

Configure the MP LAN. Refer to

Type CMto enter the Command Menu.

Type SA at the MP:CM> prompt to display and set MP remote access.

"Configuring LAN Information for the

MP".

Cabling and Power Up

Table of Contents

Integrity rx7640 9000 rp7440