Completing The Installation - HP DL320 - ProLiant - G3 Manual

Highdensity deployment

Hide thumbs Also See for DL320 - ProLiant - G3:

Table of Contents

hp ProLiant DL320 generation 2 server high-density deployment technical white paper

WARNING: To reduce the risk of electrical shock or damage to the equipment:

IMPORTANT: In Compaq branded 7000-series racks, route the power cables from the servers

to the PDUs through the gap in the rear of the rack rail.

remote console management

The remote console management system uses a CAT5 cable connected to the RJ-45 connector in

the Remote Insight Lights-Out PCI board and the power cord. Route these cables through the

cable management system according to the instructions either in the HP ProLiant DL320

Generation 2 Server Setup and Installation Guide or the HP Sliding Rails and Cable

Management Guide for the ProLiant DL320 Generation 2 Server. Connect the power cord to the

PDU and the CAT5 cable to the network data line outlet.

completing the installation

To complete the installation:

1. Install side panels on the outsides of the end racks.

2. Install the front and rear doors.

3. Connect the PDUs to the power source.

4. Power up the servers.

Unplug the power cord from the system.

Do not disable the power cord grounding plug. The grounding plug is an important

safety feature.

Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible

at all times.

Do not route the power cord where it can be walked on or pinched by items placed

against it. Pay particular attention to the plug, electrical outlet, and the point where the

cord extends from the server.

Table of Contents

Proliant dl320 g2