Table of Contents
Advertisement
Care & Cleani
CLEANING THE BURNER GRATES,BURNER CAPS,
BURNER HEADS,SIMMER P TE AND GRIDDLE
..........
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
[]
[]
[]
Electrode
The Burner Grates, Burner Caps, Burner Heads, simmer plate
and griddle should be routinely cleaned, Keeping the burner
ports clean will prevent improper ignition and an uneven
flame,
Refer to the following instructions:
To Remove and Replace the Surface Burner Grate, Surface
Burner Cap
and Surface Burner Head - Remove in the following order: (1st) Surface
Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner Head;
18000BTU Dual Flame Burners Only (See Figure).
Reverse the procedure above to replace the Surface Burner Cap, Surface
Burner Head and Surface Burner Grate. Do not remove any burner parts
)from the cooktop
until the burner parts have completely
cooled
and are
safe to handle. Do not operate the surface
burners
without
the Surface
Burner Caps, Surface Burner Heads and Surface Burner Grates properly
in place.
To Clean the Burner Caps, Burner Heads, Burner Grates, Simmer Plate and Griddle
- Use a soap-filled scouring pad or a mild abrasive cleaner to clean the surface burner
caps and surface burner heads. The Grates, Simmer Plates and Griddle are designed to
be Dishwasher safe for cleaning. The ports (or slots) around the burner heads must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle
to clean the slots or holes being careful not to damage the electrode. For proper flow of
gas and ignition of the burner--DO
NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.
ALWAYS
make sure that the surface burner cap, the surface burner head and the surface
burner grate are properly in place whenever a surface burner is in use.
Surface Burner
Surface Burner
Surface Burner
Grate ( 3 )
Caps ( 6 )
Heads
THE COOKTOPIS NOT REMOVABLE.Do not attemptto removeor lift the cooktop.
Advertisement
Table of Contents
