Configure Storm Control From Configuration Mode - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Configure storm control from CONFIGURATION mode

Configure storm control from CONFIGURATION mode using the command storm control. From

CONFIGURATION mode you can configure storm control for ingress and egress traffic.

Do not apply per-VLAN QoS on an interface that has storm-control enabled (either on an interface or

On the E-Series, when broadcast storm-control is enabled on an interface or globally on the ingress and

DSCP marking for a DSCP value 1 is configured for the data traf f ic, the traffic goes to queue 1 instead

of queue 0. Similarly, if unicast storm-control is enabled on an interface or globally on the ingress, and

DSCP marking for a DSCP value 2 is configured for the data traf f ic, the traffic goes to queue 2 instead

Storm Control