Setting A Pace And Measuring (Target Pace Function) - Epson SF-710 User Manual
Gps sports monitor
Hide thumbs
Also See for SF-710:
- User manual (149 pages) ,
- Ios user's manual (40 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
SF-710/510/310
User's Guide
Setting a Pace and
Measuring (Target Pace
Function)
You can use this function to sound an alarm if you fall
behind the pace set as the target pace during measuring.
Set your target time for one kilometer (target pace) and
the range at which the alarm sounds when you fall
behind that target pace.
c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
"Specifying a GPS (GPS Positioning)" on
U
page 28
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes or Failed is
displayed, we recommend selecting Cancel,
moving to a different location, and trying
again.
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
Measure
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
Note:
❏ You can skip GPS positioning if you want to
start measuring immediately or if it is taking
too long.
"Skipping GPS positioning" on page 29
U
❏ Use indoor mode when GPS positioning
cannot be performed because you are indoors
and so on.
"Indoor mode (SF-710/SF-510 only)" on
U
page 30
B
Displays the Mes. Settings menu.
Hold down B on the measurement screen.
C
Select Target Pace.
Use C/D to select, and then press A.
D
Select settings 1, 2, or 3.
Use C/D to select, and then press A.
59
Advertisement
Table of Contents
