Table of Contents
Advertisement
1
2
3
4
5
PRESET / MENU
6
MENU
7
8
9
10
DOCK SEL
TIME SYNC
11
12
13
14
15
DMP- 690
Using The Remote Control
The CR2032 lithium battery is already installed in the remote control. Pull out the
small mylar insulation tab as shown in the illustration to begin using the remote
control.
To use the remote controller, point the remote control transmitter on the remote
control toward the remote control receiver on the front panel of the main unit and
press the desired button. The effective range of the remote controller is
approximately 20 feet. Please note that bright sunlight or artificial light may interfere
with the proper operation of the remote control.
Battery Replacement
When the remote operation becomes weak or intermittent, it is time to replace the
remote control battery. Pull out the battery holder, remove the old battery and install a
new CR2032 battery in the holder as shown in the illustration. Slide the holder back
into the remote control.
NOTE: If the battery is installed incorrectly the remote control will not work.
REMOTE CONTROL
16
17
18
19
20
21
22
P
1.
Remote Control Transmitter
2.
STANDBY / ON Button
3.
SLEEP Button
4.
SNOOZE / DIMMER Button
5.
MODE Button
6.
PRESET / MENU - Button
7.
MENU Button
8.
TUNE / SKIP
9.
ENTER Button
10. DOCK SELECT / TIME SYNC Button
11. PLAY / PAUSE
12. ALM1 Button
13. EQ Button
14. ALM2 Button
15. VOLUME
Button
16. MUTE Button
17. FM ST Button
18. PRESET / MENU + Button
19. TUNE / SKIP
20. TIME SET / MEMORY Button
21. DBBS Button
22. VOLUME
Button
9
Button
/
Button
Button
- Quick Links:
- Operating Instructions
- Alarm Setting
Hide quick links:
Advertisement
Table of Contents
