Summary of Contents for Harbor Freight Tools 95641
Page 1
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
Provide barriers or shields as needed. electRical saFety grounded tools must be plugged into an outlet properly installed and grounded in accordance with all codes and ordinances. never remove the SKU 95641 For technical questions, please call 1-800-444-3353. Page 2...
Any tool that cannot be controlled with the Power Switch is dangerous and must be re- placed. SKU 95641 For technical questions, please call 1-800-444-3353. Page 3...
Rules Maintain labels and nameplates on the product. These carry important infor- mation. If unreadable or missing, contact Harbor Freight Tools for a replacement. Maintain a safe working environment. Make sure there is adequate surrounding workspace.
Page 5
(8A and 8B) as well as both Drive Shafts (6B and 6C) cool at least 15 minutes before touching. do not recharge the battery pack (16) if it is hot. ReV 09i; 09j SKU 95641 For technical questions, please call 1-800-444-3353. Page 5...
(see table a.) When using more than one extension cord to make up the total length, make sure each cord contains at least the minimum wire size required. (see table a.) SKU 95641 For technical questions, please call 1-800-444-3353. Page 6...
Page 7
* Based on limiting the line voltage drop to five volts at 150% of the rated amperes. symbology Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. Volts Alternating Current Amperes No Load Revolutions per Minute n 0 xxxx/min. (RPM) SKU 95641 For technical questions, please call 1-800-444-3353. Page 7...
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover page of this manual as soon as possible.
Page 9
Replace the Transmitter Battery Compartment cover. After reading the Operation Instructions carefully you may launch your Boat. note: see photo on page 16 of this manual for complete idea of inside hull layout. SKU 95641 For technical questions, please call 1-800-444-3353. Page 9...
Insert the Battery Pack (16) into the Battery Compartment and fasten down the Deck Cabin (1) using the two lock buttons at the back of the Deck Cabin (1) and one at the front. ReV 07e; 08i SKU 95641 For technical questions, please call 1-800-444-3353. Page 10...
Throttle is at it’s minimum position. throttle lever: Controls the speed of the Boat and it’s movement forward. inverter buttons: Used for changing direction for steering. This boat cannot travel in reverse, however. ReV 07e SKU 95641 For technical questions, please call 1-800-444-3353. Page 11...
Page 12
Once the power is depleted the Boat will stop. Always make sure you are away from others while using your Boat in order to pre- vent accidents and/or personal injury. SKU 95641 For technical questions, please call 1-800-444-3353. Page 12...
Replace Transmitter (20) batteries. turns without Someone else is operating a Radio Change frequency crystals on your being controlled. Controlled device in the area. Transmitter (20) and boat. ReV 07f SKU 95641 For technical questions, please call 1-800-444-3353. Page 13...
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. ReV 07g SKU 95641 For technical questions, please call 1-800-444-3353. Page 14...
If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not avail- able individually as replacement parts. ReV 07g SKU 95641 For technical questions, please call 1-800-444-3353. Page 15...