Table of Contents
Advertisement
MAINTENANCE
Begin with either side and put the motion
control lever into the neutral position. Adjust
the motion control linkage by rotating the
double nuts (D) in the proper direction until
the wheel stops rotating. See illustration.
Move the motion control lever forward then
into the neutral position and place it into the
neutral slot. The wheel must be stopped
completely at this point. Now do the same in
reverse and release the lever. The lever
should return to neutral on its own. If not see
reverse spring detent adjustment.
Run engine full throttle to make sure wheels
do not rotate. Readjust if any rotation occurs.
Repeat the whole process for the opposite
side and tighten the nuts against the ball
joints.
Turn machine off.
Reinstall the seat rod and check the wiring
harness to the seat safety switch for a good
connection and return the seat to the normal
position.
38
- Quick Links:
- Engine
Hide quick links:
Advertisement
Table of Contents
