Adding Ip Multicast Group Addresses - Cisco SF200-24 Administration Manual
Small business 200 series smart switch
Hide thumbs
Also See for SF200-24:
- Quick start manual (57 pages) ,
- Administration manual (337 pages) ,
- Datasheet (11 pages)
Table of Contents
Advertisement
Configuring Multicast Forwarding
Adding IP Multicast Group Addresses
STEP 10
Adding IP Multicast Group Addresses
STEP 1
STEP 2
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
•
Static—Attaches the interface to the Multicast group as a static member.
•
Dynamic—Indicates that the interface was added to the Multicast group as
a result of IGMP/MLD snooping.
•
Forbidden—Specifies that this port is not allowed to join this group on this
VLAN.
•
None—Specifies that the port is not currently a member of this Multicast
group on this VLAN.
Click Apply, and the Running Configuration file is updated.
Entries that were created in the
NOTE
cannot be deleted in this page (even if they are selected).
IP Multicast Group Address
The
except that Multicast groups are identified by IP addresses.
IP Multicast Group Address
The
groups.
To define and view IP Multicast groups:
Click Multicast> IP Multicast Group Address. The
page opens.
The page displays all of the IP Multicast group addresses learned by snooping.
Enter the parameters required for filtering.
•
VLAN ID equals to—Define the VLAN ID of the group to be displayed.
•
IP Version equals to—Select IPv6 or IPv4.
•
IP Multicast Group Address equals to—Define the IP address of the
Multicast group to be displayed. This is only relevant when the Forwarding
mode is (S,G).
IP Multicast Group Address
page is similar to the
page enables querying and adding IP Multicast
IP Multicast Group Address
15
page
MAC Group Address
page
200
Hide quick links:
Advertisement
Table of Contents
