Your First Qso - Kenwood TH-F6A Instruction Manual
Multi/dual-band portable transceiver
Hide thumbs
Also See for TH-F6A:
- Service manual (157 pages) ,
- Instruction manual (64 pages) ,
- Quick reference (2 pages)
Table of Contents
Advertisement
YOUR FIRST QSO
FIRST QSO
Are you ready to give your TH-F6A/ TH-F7E a quick
try? Reading this page should get your voice on the
air right away. The instructions below are intended
only for a quick guide. If you encounter problems or
there is something you would like to know more, read
the detailed explanations given later in this manual.
6 7 8
4
1
q Presss and hold [
] (POWER) briefly to switch
the transceiver power ON.
•
Do not press the switch for more than
approximately 2 seconds; the transceiver will
be switched OFF.
•
A high pitched double beep sounds and then
"KENWOOD" and "HELLO!!" appears
momentarily. The various indicators and 2
frequencies appear on the LCD.
w Press [A/B] to select the frequency band on top.
•
Each time you press [A/B], the "s" icon
moves, indicating which frequency band is
currently selected for operation.
e Turn the VOL control clockwise to the 11 o'clock
position.
3
5
2
r Press [BAND] until you select the amateur radio
band you wish to operate.
t Turn the Tuning control to select the receive
frequency.
• You may further turn the VOL control to adjust
the volume level of the signal.
y To transmit, hold the transceiver approximately
5 cm (2 inches) from your mouth.
u Press and hold the PTT switch, then speak in your
normal tone of voice.
i Release the PTT switch to receive.
o Repeat steps y, u and i to continue
communication.
3
- Quick Links:
- Instruction Manual
- Display
- Memory Scan
Hide quick links:
Advertisement
Table of Contents
