Connect Vent - Whirlpool 27" Installation Instructions Manual

27" (69 cm) electric washer/dryer

Hide thumbs Also See for 27":

Table of Contents

Enlarged version

CONNECT INLET HOSES

Check for leaks

Turn on water faucets to check for leaks. A small amount of

water may enter washer. It will drain later.

Secure drain hose

Laundry Tub

Standpipe

4.5"

(114 mm)

(113 mm)

(114 mm)

(113 mm)

Secure drain hose to laundry tub leg, drain standpipe, or inlet

hoses for wall standpipe with shipping strap removed earlier.

CONNECT VENT

Wall

4.5"

(113 mm)

(114 mm)

Connect vent to exhaust outlet

Connecting from front

(for closet or recessed

area)

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

Move washer/dryer to final location

Move washer/dryer to final location, taking care not to crush

or kink vent.

After washer/dryer is in place, remove corner posts and

cardboard from under washer/dryer.

Connecting

from rear

Table of Contents