Cisco Small Business 200 Series Administration Manual page 32
Small business 200 series smart switch
Hide thumbs
Also See for Small Business 200 Series:
- User manual (428 pages) ,
- Administration manual (202 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Administration: System Log
Setting System Log Settings
•
Error—System is in error condition.
•
Warning—System warning has occurred.
•
Notice—System is functioning properly, but a system notice has occurred.
•
Informational—Device information.
•
Debug—Detailed information about an event.
You can select different severity levels for RAM and Flash logs. These logs are displayed in the RAM
Memory page and Flash Memory page, respectively.
Selecting a severity level to be stored in a log causes all of the higher severity events to be automatically
stored in the log. Lower severity events are not stored in the log.
For example, if Warning is selected, all severity levels that are Warning and higher are stored in the log
(Emergency, Alert, Critical, Error, and Warning). No events with severity level below Warning are stored
(Notice, Informational, and Debug).
To set global log parameters:
STEP 1
STEP 2
•
Logging—Select to enable message logging.
•
Syslog Aggregator—Select to enable the aggregation of SYSLOG messages and traps. If enabled,
identical and contiguous SYSLOG messages and traps are aggregated over the specified Max.
Aggregation Time and sent in a single message. The aggregated messages are sent in the order of
their arrival. Each message states the number of times it was aggregated.
•
Max. Aggregation Time—Enter the interval of time that SYSLOG messages are aggregated.
•
Originator Identifier—Enables adding an origin identifier to SYSLOG messages. The options are:
-
None—Do not include the origin identifier in SYSLOG messages.
-
Hostname—Include the system host name in SYSLOG messages.
-
IPv4 Address—Include the IPv4 address of the sending interface in SYSLOG messages.
-
IPv6 Address—Include the IPv6 address of the sending interface in SYSLOG messages.
-
User Defined—Enter a description to be included in SYSLOG messages.
•
RAM Memory Logging—Select the severity levels of the messages to be logged to the RAM.
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Administration > System Log > Log Settings.
Enter the parameters.
4
31
Hide quick links:
Advertisement
Table of Contents
