hit counter script
Toro 20099 Operator's Manual
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. 20099
  6. Operator's manual
Toro 20099 Operator's Manual

Toro 20099 Operator's Manual

21in super recycler lawn mower serial no. 290000001 and up
Hide thumbs
Table of Contents

Advertisement

Quick Links

21in Super Recycler
Model No. 20099—Serial No. 290000001 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product.
Figure 1
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®

Lawn Mower

(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
Important: This engine is not equipped with a
spark arrester muffler. It is a violation of California
Public Resource Code Section 4442 to use or operate
the engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
This spark ignition system complies with Canadian
ICES-002.
The enclosed Engine Owner's Manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California
Emission Control Regulation of emission systems,
maintenance, and warranty. Replacements may be
ordered through the engine manufacturer.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
engine manufacturer in accordance with SAE J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine horsepower on this class
of lawn mower will be significantly lower.
Register at www.Toro.com.
Form No. 3362-510 Rev A
Operator's Manual
Figure 2
Warning
CALIFORNIA
Proposition 65 Warning
or other reproductive harm.
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading

Related Manuals for Toro 20099

Summary of Contents for Toro 20099

  • Page 1: Lawn Mower

    This manual uses 2 words to highlight information. additional information, contact an Authorized Service Important calls attention to special mechanical Dealer or Toro Customer Service and have the model information and Note emphasizes general information and serial numbers of your product ready. Figure 1 worthy of special attention.

  • Page 2: General Operation

    Safety removing grass catcher, or unclogging the discharge guard. This lawn mower meets or exceeds the CPSC blade • Operate machine only in daylight or good artificial safety requirements for walk-behind rotary lawn mowers light. and the B71.1 specifications of the American National •...

  • Page 3: Safe Handling Of Gasoline

    Service Exhaust contains carbon monoxide, an Safe Handling of Gasoline odorless, deadly poison that can kill you. To avoid personal injury or property damage, use Do not run the engine indoors or in an enclosed extreme care in handling gasoline. Gasoline is area.

  • Page 4: Assembling And Unfolding The Handle

    Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1. Assembling and Unfolding 112-8867 the Handle 1. Lock 2. Unlock Procedure Assembling and unfolding the handle improperly can damage the cables, causing an unsafe operating condition. 114-7982 •...

  • Page 5: Filling The Engine With Oil

    2. Filling the Engine with Oil Procedure Your mower does not come with oil in the engine. 1. Remove the dipstick (Figure 5). Figure 4 4. Lock the handle at your desired height. Refer to Adjusting the Handle Height in the Operation section.

  • Page 6: Product Overview

    Product Overview Operation Filling the Fuel Tank Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a vehicle or on an object.

  • Page 7: Checking The Engine Oil Level

    Checking the Engine Oil Level Adjusting the Cutting Height Service Interval: Before each use or daily 1. Remove the dipstick, wipe it clean, and insert it into the oil filler neck, but do not screw it in (Figure 9). Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury.

  • Page 8: Adjusting The Handle Height

    Adjusting the Handle Height You may raise or lower the handle to a position comfortable for you. Rotate the handle lock, move the handle to one of three positions, and lock the handle into position (Figure 11). Figure 13 Note: If the mower does not start, contact an Authorized Service Dealer.

  • Page 9: Stopping The Engine

    Stopping the Engine Release the blade control bar (Figure 15). Important: When you release the blade control bar, the blade should stop within 3 seconds. If it does not stop properly, stop using your mower immediately and contact an Authorized Service Dealer.

  • Page 10: Bagging The Clippings

    Check the grass bag frequently. If it is 1. Discharge deflector 2. Rear discharge plug damaged, install a new Toro replacement bag. 3. Rotate the lock counterclockwise on the mulch plug If the side discharge chute is on the mower, remove it to the unlocked position (Figure 21).

  • Page 11: Removing The Grass Bag

    Removing the Grass Bag 1. Route the starter rope around the lower rope guide (Figure 23). Figure 25 2. Rear discharge plug 1. Discharge deflector 5. Rotate the lever lock clockwise into the locked position (Figure 26). Figure 23 1. Lower rope guide Note: The lower rope guide releases the starter rope when you pull the recoil start handle.

  • Page 12: Side-Discharging The Clippings

    Side-discharging the Clippings Installing the Side Discharge Chute 1. Unlock the side discharge door (Figure 28). Use the side discharge for cutting very tall grass. If the bag is on the mower, remove it and insert the rear discharge plug (refer to Removing the Grass Bag) before side-discharging the clippings.

  • Page 13: Operating Tips

    • Slow down your mowing speed if the mower does cutting season begins. not cut the leaves finely enough. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time.

  • Page 14: Recommended Maintenance Schedule(S)

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •...

  • Page 15: Changing The Engine Oil

    Servicing the Air Cleaner Changing the Engine Oil Element Service Interval: After the first 5 hours Every 50 hours/Yearly (whichever Service Interval: Every 25 hours/Yearly (whichever comes first) comes first)—Check the air cleaner for dirty, loose, or damaged parts, and Run the engine a few minutes before changing the oil clean or replace them if necessary.

  • Page 16: Lubricating The Wheel Gears

    Lubricating the Wheel Gears 4. Slowly pour oil into the oil fill tube until the oil level reaches the Full line on the dipstick (Figure 34). Service Interval: Every 25 hours Do not overfill. (Max. fill: 22 oz. (0.65 l), type: 10W-30 or SAE 30 detergent oil with an API service 1.

  • Page 17: Cleaning The Mower

    Cleaning the Mower Service Interval: Before each use or daily The mower may dislodge material from under the mower housing. • Wear eye protection. • Stay in the operating position (behind the Figure 38 handle) when the engine is running. •...

  • Page 18: Preparing The Mower For Storage

    Folding the Handle Storage 1. Rotate the handle forward (Figure 41). Store the mower in a cool, clean, dry place. Important: Route the cables to the outside of the handle knobs as you fold the upper handle. Preparing the Mower for Storage Gasoline vapors can explode.
  • Page 19 Notes:...
  • Page 20 Notes:...
  • Page 21 Notes:...

  • Page 22: The Toro Starting Guarantee

    Toro Engine will start on the first or second pull for five years rotary mower blade striking an object from the date of purchase—if you provide the routine maintenance contaminants in the fuel system it requires—or we will fix it free of charge.
  • Page 23 Date Hours Air Cleaner Change Oil Lubricate Wheels Check Spark Storage Used Service (does not apply (mowers only) Plug Preparation (mowers only) to two-cycle) Part No. 374-0018 Rev. F...

  • Page 24: The Toro Total Coverage Guarantee

    If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.

Table of Contents