Table of Contents
Advertisement
dCS Scarlatti DAC User Manual
STEP 2 – Connecting the Analogue Outputs
Choose one of the following two sections:
Using a preamplifier
• Set the preamplifier volume control to minimum.
• Connect either the balanced (XLR connectors) or unbalanced (RCA phono connectors) outputs on
DAC rear panel to matching line level inputs on your preamplifier (probably labelled CD or AUX).
• Turn the DAC rotary control clockwise to set the
Slowly increase the preamplifier volume until the music is at the right level.
Using a power amplifier directly
• Turn the DAC rotary control counter-clockwise to set the
display).
• Connect either the balanced (XLR connectors) or unbalanced (RCA phono connectors) outputs on
the DAC rear panel to matching inputs on your power amplifier. Switch on the power amplifier.
• Turn the DAC rotary control slowly clockwise until the music is at the right level.
Play a disc, you should have audio.
Proceed to Step 3.
AES 1
ANALOGUE OUTPUTS
LEFT
L
Balanced - or - Unbalanced
Analogue Outputs
To pre- or power amplifier inputs
Flename: Scarlatti DAC Manual v1_2x.docx
DIGITAL
CH1
SDIF
OUTPUTS
IN ---- WORDCLOCK --- OUT
AES 2
RCA
BNC
TOSLINK
LEFT
DIGITAL INPUTS
RIGHT
AES 1
AES 2
RIGHT
R
L
R
Figure 1 – Basic setup
Volume
to maximum
Volume
CH2
SUC
1394
RCA 1
DSD/SDIF
CH 1
CH 2
TOSLINK
SPDIF
BNC
OUT
IN
RCA 2
WCLK
Page 8
Software Issue 1.2x
August 2011
(- 0.0dB
on the display).
to minimum (
-60.0dB
Scarlatti Transport
Scarlatti DAC
~
1394
50/60 Hz, 50W
FUSE
SUC
T 500mA L
English version
on the
Advertisement
Table of Contents
