Table of Contents
Advertisement
Configuring Copy Settings
Configuring Copy Settings
You can change the copy settings to alter the output to suit your needs. Each setting can be configured
from the [Change Settings] menu on the copy standby screen.
Perform the following procedures at step 3 of
Reference
The changes made in the [Change Settings] menu on the copy standby screen are temporary. You can change the default
settings by configuring [Admin Setup] from the <SETTING> key. For details, refer to the User's Manual Advanced.
Changing the Scan Size (Scan Size)
You can select the appropriate size of the
document to be scanned.
Press the
to enter the [Change
1
Settings] menu.
Check that [Scan Size] is selected and
2
then press
.
OK
Press the
to select a scan size and
3
then press
.
OK
Settable Values:
A4*
A5
A6
Legal 13.5
Legal 14
*indicates the factory default.
Press the
until the start screen is displayed.
4
Note
If you select the scan size of less than or equal to
177.8mm (7 inches) wide, and make copies from ADF,
Scan Resolution is changed to High Quality automatically.
Changing the Paper Tray
(Paper Feed)
You can select the size of the document to be copied.
Press the
to enter the [Change
1
Settings] menu.
Press the
to select [Paper Feed] and
2
then press
.
OK
B5
Letter
Legal 13
Executive
"Starting a Copy Job" P. 77
Press the
3
press
OK
Settable Values:
Auto*
Press the
4
Memo
[Tray 2] is displayed only when the optional second tray
unit is installed.
When set to [Auto], the MP tray is not selected in the
default setting. To use the MP tray, press the <SETTING>
key and select [Paper Setup] > [Select Tray] > [Copy] >
[MP tray], and then select [ON] or [ON (Prior)].
When set to [Auto], the paper tray that holds paper other
than A4, B5, A5, A6, letter, legal 13/13.5/14, or executive
is not selected. To use a different paper size, select the
desired paper tray in the [Paper Feed Tray] setting.
Copying Using the MP Tray
If you have selected [MP Tray], you can copy your
documents onto the paper loaded in the MP tray.
Place your document with text face up in the
1
ADF or face down on the document glass.
Load the paper in the MP tray.
2
Press
3
M
ONO
When the pop-up message is displayed,
4
press the
then press
Reference
For details on how to load the paper in the MP tray, refer to
"Loading Paper on the MP Tray (e-STUDIO403S)" P.
- 78 -
described above.
to select a tray and then
.
Tray 1
Tray 2
MP Tray**
*indicates the factory default.
**Not displayed in e-STUDIO332S.
until the start screen is displayed.
.
or
to select [Start] and
.
OK
38.
Advertisement
Table of Contents
