Table of Contents
Advertisement
Quick Links
DUSTLESS CIRCULAR SAW
MODEL C 5YA
HANDLING INSTRUCTIONS
Note:
Before using this Power Tool, carefully read through these HANDLING
INSTRUCTIONS to ensure efficient, safe operation. It is recommended that
these INSTRUCTIONS be kept readily available as an important reference
when using this power tool.
Advertisement
Table of Contents
Related Manuals for Hitachi C 5YA
Summary of Contents for Hitachi C 5YA
-
Page 1: Handling Instructions
DUSTLESS CIRCULAR SAW MODEL C 5YA HANDLING INSTRUCTIONS Note: Before using this Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool. -
Page 2: General Operational Precautions
16. Remove adjusting keys and wrenches. Form the GENERAL OPERATIONAL PRECAUTIONS habit of checking to see that keys and adjusting wrenches are removed from the tool before turning WARNING! When using electric tools, basic safety it on. precautions should always be followed to reduce the 17. -
Page 3: Specifications
SPECIFICATIONS Model C5YA Voltage 230 V Cutting Depth 37 mm Max. Power Input 1000 W Capacity 125 mm Max. Full Load Amp. 4.6 A Dimensions (Length × Heigth × Width) 284 mm × 208 mm × 320 mm No Load Speed 5000/min Weight (without cord) 3.1 Kg... -
Page 4: Cutting Procedures
2. Aligning the position of the saw blade CUTTING PROCEDURES (1) Align the position of the cutting edge of the blade using the standard line on forward edge of the table 1. Place the base on the workpiece, then align the insert portion of the base plate (See Fig. -
Page 5: Mounting And Dismounting The Saw Blade
(3) Pull the dust box in the direction indicated by arrow 2. Dismounting the dust box “A”. (See Fig. 7) Loosen the lever and set the base at minimum cutting depth and dismount the dust box by going through the steps for mounting in reverse order. Gear cover MOUNTING AND DISMOUNTING THE SAW BLADE... - Page 6 (4) Put the provided collar into washer (A). (1) Push on the hook which located in the rear of the (5) Align the beveled part of the spindle parallel with dust box. Open the dust cover and empty out the the guide line on the safety cover.
-
Page 7: Maintenance And Inspection
NOTE brush No. shown in the figure when they become Due to HITACHI’s continuing program of research and worn to or near the “wear limit”. In addition, always development, the specifications herein are subject to keep carbon brushes clean and ensure that they change without prior notice. - Page 8 Code No. C99067611 N Printed in Japan...