Hitachi GP2 User Manual
Sidepower tunnel cut-out tool
Hide thumbs
Also See for GP2:
- Handling instructions manual (50 pages) ,
- Instruction manual (48 pages) ,
- Parts list (4 pages)
Related Manuals for Hitachi GP2
Summary of Contents for Hitachi GP2
- Page 1 User manual Sidepower Tunnel Cut-out Tool Art. No. 6 8870 / 6 8871 Sleipner Motor A/S Ver.1 - 2007...
- Page 2 Sleipner Motor A/S...
- Page 3 Tunnel Cut-out tool adjusted for 300mm tunnel diamete Sleipner Motor A/S...
- Page 4 Assemble the cut-out tool, and adjust it to the right tunnel diameter. After finger-tightening the two threaded handles, tighten the adjustment-screw to get the right A-distance Thruster Position at cut-out tool Distance A SP35S Min. 74mm Min. 2 ” SP55S, SP75T, SP95T, Min.
- Page 5 Adjustment-screw at Ø125mm tunnel Adjustment-screw at Ø386mm tunnel Sleipner Motor A/S...
- Page 6 Insert the cut-out tool through both ø12mm holes. Start the grinder and mark the cutting path by frimly rotating the cut-out tool. Be careful to avoid flexing the rod. Use eye- and earprotection. Cut out the hole for the tunnel. NB! Leave 3 small spots to maintain the bearing until you have cut out the hole on the oposite side of the boat.
- Page 7 Insert the cut-out tool through both ø12mm holes. Start the grinder and mark the cutting path by frimly rotating the cut-out tool. Be careful to avoid flexing the rod. Use eye- and earprotection. Cut out the hole for the tunnel. NB! Leave 3 small spots to maintain the bearing until you have cut out the hole on the oposite side of the boat.
- Page 8 Insert the cut-out tool through both ø12mm holes. Start the grinder and mark the cutting path by frimly rotating the cut-out tool. Be careful to avoid flexing the rod. Use eye- and earprotection. Cut out the hole for the tunnel. NB! Leave 3 small spots to maintain the bearing until you have cut out the hole on the oposite side of the boat.