Table of Contents
Advertisement
7.8.10 The number of HDCP retries
Menu
Top→OUTPUT SETTING→HDCP ERROR RETRY
Setting for
Each output (each OUTA / OUTB)
Setting value ETERNITY
0 to 100
If a sink device with HDCP is connected and you set "7.8.9 HDCP" to "HDCP INPUT ONLY" or "ALWAYS",
HDCP is authorized regardless of the status of input signal. Normally, set this menu to "ETERNITY" to retry
the authentication automatically after the first authentication fails. However, you can set the number of retries
manually. (If retry is not succeeded even after the MSD retries for the set number of retry times, video and
audio with HDCP are not output.)
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
7.8.11 Deep Color
Menu
Top→OUTPUT SETTING→DEEP COLOR OUTPUT
Setting for
Each output (each OUTA / OUTB)
Setting value 24-BIT COLOR [Default], 30-BIT COLOR
You can select the color depth of HDMI signal.
"30-BIT COLOR": signal is output with "30-BIT COLOR" only if a sink device supporting Deep Color is
connected. If a sink device that does not support Deep Color is connected, signal is output with "24-BIT
COLOR" automatically. However, since the transmission clock of "30-BIT COLOR" is faster than that of
"24-BIT COLOR", noise may occur if a bad-quality cable or long cable is connected. In those cases, the noise
may be removed by selecting"24-BIT COLOR".
: retry until succeeded [Default],
: 0 to 100 times
MSD-501/502/701/702 User's Guide
53
Advertisement
Table of Contents
