Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
a.
Remove the battery (see
b.
Remove the fan (see
c.
Remove the system board (see
d.
Remove the display assembly (see
Remove the power connector cable:
1.
Release the power connector cable (1) from the retention clips built into the bottom cover.
2.
Remove the Phillips PM2.0×4.1 screw (2) that secures the power connector to the top cover.
3.
Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
40
Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
23).
Fan on page
27).
System board on page
Display assembly on page
22), and then remove the following components:
31).
37).
Spare part number
801513-001
Hide quick links:
Advertisement
Table of Contents
