Hdd Slot, Order Of Installation, And Indicator; Hdd Slot And Order Of Installation - Hitachi Compute Blade 500 Series System Overview Manual
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Location
10
11
Notes:
1
When using the USB port of KVM cable except keyboard and mouse, you should use
.
the device with a rated maximum current limit 500 mA per two ports, or the USB
device that can be external powered.
2
When POWER LED starts blinking from lighting solid, release the button. If you press
.
the power switch for six seconds or more, the power may turn on after forced turn-
off. If so, check that HDD access LED is not illuminated, and then press and hold the
power button for four seconds or more.
3
Error cannot be displayed while from pressing the power button until turning on the
.
main power.
HDD slot, order of installation, and indicator
HDD slot and order of installation
Name
QPI Link Status LED (LNK)
Diagnostic Panel LP
Figure 1-22 Half-wide Blade
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State
Green-On
Green-On
S BRD
Amber-On
MIS
Amber-On
NMI
Amber-On
TEMP
Amber-On
MEM
Amber-On
ADJ
-
Description
QPI is linked in SMP
configuration.
The LED panel is active.
The motherboard needs to
be replaced.
Unsupported combination
of the DIMM, CPU, and
HDD.
A Non-Maskable Interrupt
(NMI) was generated.
The maximum temperature
limit was exceeded.
A memory failure was
detected.
Not supported.
1-21
- Quick Links:
- Server Chassis (Enclosure)
- Power Distribution
Hide quick links:
Advertisement
Table of Contents
