Table of Contents
Advertisement
Step 9. Attach the Display Cable Toroid
If the cable for your display came with a separate toroid, install the toroid using the installation instructions
included with the toroid.
Step 10. Connect the Graphics Display
Note: If you have an ASCII terminal, you must connect it to the serial connector S1 (item 1 in the
following illustration). If you are using an ASCII terminal as the console for this system, and do not
have a graphics display to connect, continue with "Step 12. Connect the Serial and Parallel
Devices" on page 20.
Connect the graphics display cable to the back of the display and to the graphics adapter connector. For
the locations of installed adapters, consult the "About Your Machine" document.
For more information about your display, refer to the documentation included with the display.
Notes:
1. The PCI graphics adapter might be installed in any of the PCI slots on the system unit.
2. Some displays require an additional cable.
18
Eserver pSeries 650 Installation Guide
1 Display Cable Toroid
1 Serial Connector S1
Advertisement
Table of Contents
