Connecting Your Pc Or Macintosh Computer - NEC HT1000 User Manual
Entertainment projector
Hide thumbs
Also See for HT1000:
- User manual (66 pages) ,
- Brochure & specs (6 pages) ,
- Installation manual (6 pages)
Table of Contents
Advertisement
Connecting Your PC or Macintosh Computer
NOTE: For older Macintosh, use
a commercially available pin
adapter (not supplied) to con-
nect to your Mac's video port.
IBM VGA or Compatibles (Desktop type)
or Macintosh (Desktop type)
Connecting your PC or Macintosh computer to your projector will en-
able you to project your computer's screen image for an impressive pre-
sentation.
To connect to a PC or Macintosh, simply:
1. Turn off the power to your projector and computer.
2. Use the supplied signal cable to connect your PC or Macintosh to the
projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused
by a screen saver installed on the computer you've connected to the
projector.
For European model only
To connect SCART output (RGB)
Before connections: The supplied SCART adapter (ADP-SC1) and a
commercially available SCART cable are required for this connection.
NOTE: Audio signal is not available for this connection.
Video equipment
such as DVD player
Commercially available
SCART cable
AUDIO IN
PC CONTROL
VIDEO IN
Audio cable (not supplied)
PHONE
Projector
To RGB IN
SCART adapter
ADP-SC1 (supplied)
RGB IN
VIDEO
VIDEO
S-VIDEO
S-VIDEO
COMPONENT
RGB/DVI
RGB/DVI
AUDIO IN
AUDIO IN
SG TRIGGER
S-VIDEO IN
DVI-D IN
Y
Cb/Pb
Cr/Pr
RGB IN
RGB signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is recommended
that you use a commercially available distribution amplifier if con-
necting a signal cable longer than the supplied one.
IBM VGA or Compatibles (Notebook type)
or Macintosh (Notebook type)
NOTE: The HT1000 is not compatible with video decoded outputs of NEC ISS-
6020 and ISS-6010.
1. Turn off the power to the projector and your video equipment.
2. Use the supplied SCART adapter and a commercially available
SCART cable to connect the RGB input of your projector and a SCART
output (RGB) of your video equipment.
3. Turn on the power to the projector and your video equipment.
4. Use the RGB button on the remote control to select the RGB input.
5. Press the MENU button on the remote control to display the menu.
6. From the Advanced menu, select [Projector Options]
[Page 3]
[Signal Select RGB]
SCART is a standard European audio-visual connector for TVs, VCRs
and DVD players. It is also referred to as Euro-connector.
E-16
PHONE
[Setup]
[Scart].
Advertisement
Table of Contents
