Set-Up Adjustments; Beam Landing - Sony KV-32XBR200 Service Manual

Hide thumbs Also See for KV-32XBR200:

Operating instructions manual (42 pages)

Supplementary manual (1 page)

Service manual (86 pages)

Table Of Contents

Table of Contents

更多难得资料请到江南家电维修论坛免费下载！

KV-32XBR200/KV-36XBR200

http://bbs.520101.com

The following adjustments should be made when a

complete realignment is required or a new picture

tube is installed.

These adjustments should be performed with rated

power supply voltage unless otherwise noted.

Set the controls and switch as follows unless

otherwise noted:

VIDEO MODE: STANDARD

PICTURE control ................. 100%

BRIGHTNESS control ......... 50%

3-1. BEAM LANDING

Preparation:

•

Input a white pattern signal.

•

Face the picture tube in a East or West direction to reduce the influence of geomagnetism.

NOTE: Do not use the hand degausser because it magnetizes the CRT .

1. Input white pattern from pattern generator.

2. Loosen the deflection yoke mounting screw, and set

the purity control to the center as shown below:

3. Input green pattern from pattern generator.

4. Move the deflection yoke backward, and adjust with

the purity control so that green is in the center and

red and blue are even on both sides.

5. Move the deflection yoke forward, and adjust so that

the entire screen becomes green.

SECTION 3