(shorting-solder) by referring to "the DISASSEMBLY". 4. After replacing the pickup unit, be sure to check the grating. 5. Be careful in handling ICs. Some ICs such as MOS type are so fragile that they can be damaged by electrostatic induction. u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
To protect products from damages or failures during transit, the shipping mode should be set or the shipping screws should be installed before shipment. Please be sure to follow this method especially if it is specified in this manual. u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
• Screw adjacent to mark on the product are used for disassembly. • For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions,apply as you think it appropriate.) 2.1 PACKING L 13942296513 u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
19-4 Caution Card CRP1310 19-5 Warranty Card See Contrast table(2) Polyethylene Bag CEG1373 Battery CEX1065 (2) CONTRAST TABLE DEH-P3950MP/XU/ES and DEH-P3950MP/XU/CN5 are constructed the same except for the following: Mark Description DEH-P3950MP/XU/ES DEH-P3950MP/XU/CN5 Case Assy CXB3520 Not used Carton YHG5116...
Antenna Jack(CN401) CKX1056 IC(IC1802) GP1UX51RK Holder CND3545 Sheet See Contrast table(2) Holder CND3703 (2) CONTRAST TABLE DEH-P3950MP/XU/ES and DEH-P3950MP/XU/CN5 are constructed the same except for the following: Mark Description DEH-P3950MP/XU/ES DEH-P3950MP/XU/CN5 Panel YNS5190 CNS8762 Tuner Amp Unit YWM5131 YWM5159 Detachable Assy...
3 7 63 1515 0 Note: When ordering service parts, be sure to refer to " EXPLODED VIEWS AND PARTS LIST" or "ELECTRICAL PARTS LIST". Large size SCH diagram CN701 Guide page Detailed page L 13942296513 SYSTEM CONTROLLER u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
10k ohms *Capacitors Code Practical value 0.01uF 101/10 100uF/10V The > mark found on some component parts indicates the importance of the safety factor of the part. Therefore, when replacing, be sure to use parts of identical designation. DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
3 7 63 1515 0 CD CORE UNIT(S10.5COMP2) SIGNAL LINE FOCUS SERVO LINE TRACKING SERVO LINE CARRIAGE SERVO LINE SPINDLE SERVO LINE L 13942296513 CN651 & u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
5 V/div 5 V/div 1 V/div 4LOEJ 0FIN 5 V/div 1 V/div Black dot(800 µm) during play 12 cm CD Eject operation 8 cm CD Eject operation Ref.: Ref.: Ref.: REFO Mode: Mode: Mode: Normal Normal Normal u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
For further information for respective destinations, be sure to check with the schematic dia- gram. CORD ASSY 2.Viewpoint of PCB diagrams Capacitor Connector IP-BUS INPUT SIDE A SIDE B P.C.Board Chip Part L 13942296513 CN701 u163 CN1801 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
4.3 CD CORE UNIT(S10.5COMP2) 3 7 63 1515 0 CD CORE UNIT(S10.5COMP2) SIDE A CN651 PICKUP UNIT(P10.5)(SERVICE) L 13942296513 LOADING /CARRIAGE MOTOR SPINDLE MOTOR u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
(B,133,31) RS1/16S473J C 152 (B,135,96) CKSRYB224K16 R 618 (B,144,39) RS1/16S473J C 153 (B,102,98) CKSRYB105K10 R 619 (B,144,37) RS1/16S104J C 154 (B,133,95) CKSRYB105K10 R 622 (B,127,25) RS1/16S104J C 155 (A,115,113) CEJQ470M10 R 638 (B,156,86) RS1/16S273J C 156 (B,134,99) CKSRYB105K10 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
PD6340A C 626 (B,127,70) CCSRCH270J50 IC 1802 (A,19,161) Remote IC GP1UX51RK D 1803 (A,7,148) LED SML-310VT C 627 (B,131,76) CCSRCH150J50 D 1804 (A,7,155) LED SML-310VT C 628 (B,139,62) CKSRYB102K50 D 1805 (A,40,148) LED SML-310VT C 629 (B,132,57) CCSRCH4R0C50 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
C 1810 (B,23,149) CKSRYB472K50 C 1802 (A,25,154) CKSRYF104Z25 C 1811 (B,23,151) CKSRYB472K50 u163 C 1803 (B,19,159) CKSYF106Z10 C 1810 (B,23,149) CKSRYB472K50 C 1811 (B,23,151) CKSRYB472K50 Unit Number : (CN5) Unit Name : Keyboard Unit Unit Number : CWX3350 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
R 307 (A,34,19) RS1/16SS183J R 308 (A,38,20) RS1/16SS183J R 309 (A,35,21) RS1/16SS183J R 310 (A,38,21) RS1/16SS183J R 601 (B,28,38) RS1/16SS0R0J u163 R 602 (B,27,41) RS1/16SS0R0J R 606 (B,23,41) RS1/16SS0R0J R 701 (B,16,35) RS1/16SS221J R 702 (A,23,55) RS1/16SS221J CAPACITORS DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
• The load and eject operation is not guarantied with the mechanism upside down. If the mechanism is blocked due to mistaken eject operation, reset the product or turn off and on the ACC to restore it. u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
• When the power is turned on/off the jump mode is reset to the Single TR (91) while the gain of the RFAMP is reset to 0 dB. At the same time all the self-adjusting values shall return to the default setting. DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Because of eccentricity in the disc and a slight misalignment of the clamping center the grating waveform may be seen to "wobble" ( the phase difference changes as the disc rotates). The angle specified above indicates the average angle. • Hint u163 Reloading the disc changes the clamp position and may decrease the "wobble". DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Remarks: Mechanical errors are not displayed (because a CD is turned off in these errors). Unreadable TOC does not constitute an error. An intended operation continues in this case. Upper digits of an error code are subdivided as shown below: 1x: Setup relevant errors, 3x: Search relevant errors, Ax: Other errors. u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
The frequency of the clock signal is 1 Hz. The clock signal should be 1 Hz ± 0.000 04 Hz. If the clock signal is out of the range, the X'tal (X601) should be replaced with new one. L 13942296513 u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Removing the Tuner Amp Unit (Fig.2) Remove the screw (BSZ26P180FTC). Remove the screw (BSZ26P100FTC). Remove the two screws. Remove the two screws. Straighten the tabs at two locations indicated and then remove the Tuner Amp Unit. u163 Tuner Amp Unit Fig.2 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Page 52
3. While lifting the Carriage Mechanism, remove it from the three Dampers. Caution: When assembling, be sure to apply some alcohol to the Dampers and assemble the mechanism in a clamped state. L 13942296513 Damper Damper Carriage Mechanism Lower Frame u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Assemble the sub unit side of the Pickup, taking the plate (Chassis) in-between. When treating the leads of the Load Carriage Motor Assy, do not make them loose over the Feed Screw. L 13942296513 Poly Washer Change Arm Pickup Lock Arm Inner Holder Feed Screw Planet Gear Pickup Rack Chassis Pickup u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Terminal for TUNER only PLL_VDD bu_reset Backup circuit reset input Terminal for TUNER only DVDD3 Terminal for TUNER only DGND2 Terminal for TUNER only L_OUT Terminal for TUNER only R_OUT Terminal for TUNER only COMP Terminal for TUNER only u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
DVDDD4 DGND3 E.VOL strobe output E.VOL data output E.VOL clock output CD mechanism power supply output VDCONT Not used Self-rewriting applied voltage input 1(fixed to L) FLMD1 Not used Wired remote control input KEYD Not used 131,132 u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
DA.VDD Power supply for DAC Output of audio for the left channel LOUT Ground for DAC DA.GND Connected to the capacitor for band gap REGC Ground for DAC DA.GND Output of audio for the right channel ROUT u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
REFOUT Reversal input of FE Output of FE ADCIN FE,TE A/D converter input Reversal input of TE Output of TE Output of LD Input of PD Power supply for servo ADC AD.VDD Ground for servo ADC AD.GND u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
18 DO Data Out Data output 19 CE2 Chip Enable-2 Chip enable for EEPROM "Low" active. in power ON/OFF, please turn CE2 into "High" (= VDD). 20 SLOUT Signal Level Output Output of FM/AM signals level (D.C.) u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
In case of the above signal, the communication Source keys with Grille microcomputer may fail. operative If the time interval is not 300 msec, the oscillator may be defective. Source ON SYSPW←H Pin 15 Completes power-on operation.(After that, proceed to each source operation.) u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...
Before shipping out the product, be sure to clean the following portions by using the prescribed cleaning tools: Portions to be cleaned Cleaning tools CD pickup lenses Cleaning liquid : GEM1004 Cleaning paper : GED-008 g p p L 13942296513 u163 DEH-P3950MP/XU/ES http://www.xiaoyu163.com...