Lenovo ThinkPad T430s User Manual page 71
Hide thumbs
Also See for ThinkPad T430s:
- User manual (212 pages) ,
- (210 pages) ,
- Benutzerhandbuch (208 pages)
Table of Contents
Advertisement
Table 4. LED behavior list_fingerprint reader (continued)
LED behavior
Blinking green
Blinking amber
Steady amber for 15 seconds
Swiping your finger over the reader
To swipe your finger over the reader, place the ball of your finger, that is, the central part of the fingerprint, on
the small circle above the reader. Make sure that the entire top joint of the finger is on the reader. Then Apply
light pressure and swipe your finger across the reader in one smooth motion.
Logging on to the system
After you enroll your fingerprint, log on to the system by doing the following:
1. Set a power-on password or a hard disk password, or both.
2. Turn your computer off and then on again.
3. When prompted, swipe your finger over the reader.
4. On request, type your power-on password, your hard disk password, or both. The enrolled fingerprint is
now associated with your power-on password, your hard disk password, or both.
The next time you start the computer, you can log on to the system by swiping your finger over the
reader once.
Attention: If you always use your fingerprint to log on to the system, you might forget your password. Write
down your password, and keep it in a safe place. If you forget it and for some reason you cannot swipe
your finger across the reader, for example, if you injure that finger, you cannot start the computer or change
the password.If you forget your power-on password, you must take your computer to a Lenovo authorized
servicer or a marketing representative to have the password canceled.
Description
The fingerprint reader is ready to swipe in power-on authentication state.
The fingerprint could not be authenticated.
The power-on authentication feature is disabled after three bad fingerprint swipes.
55
.
Chapter 4
Security
Hide quick links:
Advertisement
Table of Contents
