Adding Fuel; Check The Engine Oil Level - Toro 73546 Wheel Horse 520Lxi Operator's Manual
Hide thumbs
Also See for 73546 Wheel Horse 520Lxi:
- Operator's manual (56 pages) ,
- Service manual (93 pages) ,
- Operator's manual (52 pages)
Table of Contents
Advertisement
Check Before Operating
Adding Fuel
Use UNLEADED Regular Gasoline suitable for
automotive use (85 pump octane minimum). Leaded
regular gasoline may be used if unleaded regular is
not available.
IMPORTANT: Never use methanol, gasoline
containing methanol, or gasohol containing
more than 10% ethanol because the fuel
system could be damaged. Do not mix oil with
gasoline.
POTENTIAL HAZARD
In certain conditions gasoline is extremely
flammable and highly explosive.
WHAT CAN HAPPEN
A fire or explosion from gasoline can burn
you, others, and cause property damage.
HOW TO AVOID THE HAZARD
Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is cold.
Wipe up any gasoline that spills.
Do not fill the fuel tank completely full.
Add gasoline to the fuel tank until the level
is 1/4" to 1/2" (6 mm to 13 mm) below the
bottom of the filler neck. This empty space
in the tank allows gasoline to expand.
Never smoke when handling gasoline, and
stay away from an open flame or where
gasoline fumes may be ignited by a spark.
Store gasoline in an approved container
and keep it out of the reach of children.
Never buy more than a 30-day supply of
gasoline.
10
Filling the Fuel Tank
1.
Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
lower the attachment lift, and turn the ignition
key to "STOP" to stop the engine. Remove the
key.
2.
Clean around the fuel tank cap and remove the
cap. Use a funnel and add unleaded regular
gasoline to the fuel tank, until the level is 1/4 to
1/2 inch (6 mm to 13 mm) below the bottom of
the filler neck. This space in the tank allows
gasoline to expand. Do not fill the fuel tank
completely full.
3.
Install the fuel tank cap securely. Wipe up any
gasoline that may have spilled.
Check the Engine Oil Level
1.
Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
lower the attachment lift, and turn the ignition
key to "STOP" to stop the engine. Remove the
key.
2.
Open the hood.
3.
Clean around the oil dipstick (Fig. 4) so dirt
cannot fall into the dipstick hole and damage the
engine.
4.
Pull out the oil dipstick and wipe the metal end
clean (Fig. 5).
5.
Slide the oil dipstick fully into the tube. Pull the
dipstick out and look at the metal end. If the oil
level is near or below the "L" mark on the
dipstick, remove the filler cap and add oil only
to the "H" mark on the dipstick. (Refer to
Engine Oil, page 26, for the correct oil type and
viscosity to use in different temperature
conditions).
Hide quick links:
Advertisement
Table of Contents
