Drive System Maintenance; Checking The Torque Of The Wheel; Nuts Or Bolts; Checking The Planetary Gear Drive - Toro 03806 Operator's Manual
Traction unit
Hide thumbs
Also See for 03806:
- Operator's manual (60 pages) ,
- Operator's manual (64 pages) ,
- Service manual (328 pages)
Table of Contents
Advertisement
5. Secure ground wires from lights to the engine
block ground.
6. Install a 10 amp. fuse to fuse block at location
shown on fuse block decal. Do not exceed
fuse rating.
Switch
Toro Part No. 75-1010
Honeywell Part No. 1TL1-2
Drive System
Maintenance
Checking the Torque of the
Wheel Nuts or Bolts
Failure to maintain proper torque of the
wheel nuts could result in personal injury.
Torque the front wheel nuts and rear
wheel bolts to 85-100 ft.-lb. after 1-4 hours
of operation and again after 10 hours of
operation. Torque every 200 hours thereafter.
Checking the Planetary Gear
Drive Oil
1. With machine on level surface, position wheel
so the check/drain plug (Figure 52) is at either
2 or 10 o'clock position.
Figure 51
Relay
Toro Part No. 70-1480
Hella Part No. 87411 B
41
Figure 52
1. Check/drain plug
2. Remove the plug on the planetary (Figure 52)
and the check plug on the back side of the
brake (Figure 53).
Oil should be at the bottom of the check plug
hole on front and back side of the brake.
Hide quick links:
Advertisement
Table of Contents
