Table of Contents
Advertisement
3. Remove hair pin cotter and pull back on locking spring
flap to pivot mounting plate forward (Fig. 5).
1
Figure 5
1. Hair pin
2. Lock spring flap
4. Hold mounting plate in upright position with support
rod (Fig. 6).
1
3
2
Figure 6
1. Mounting plate
2. Support rod
5. Mount seat and spring assembly to rear holes in seat
mounting plate with two shoulder bolts, small I.D. flat
washers and locknuts (Fig. 4 & 7).
6. Secure front slot of seat springs to traction unit front
mounting holes with adjustment handles and
flatwashers (Fig. 4 & 5).
7. Connect seat switch connector to traction unit wire
harness connector.
8. Adjust seat to desired operating position. Loosen
adjustment handles, slide seat fore or aft in slotted holes
and tighten adjustment handles to secure in place.
2
3
3. Seat mounting plate
3. Indent
16
1
3
2
Figure 7
1. Mounting plate
2. Seat spring
Seat Kit, Model No. 30625, Deluxe Seat:
1. Position threaded mounting studs of seat suspension
into holes in seat mounting plate.
2. Remove hair pin cotter and pull back on locking spring
flap to pivot mounting plate forward (Fig. 5).
3. Hold mounting plate in upright position with support
rod (Fig. 6).
4. Secure seat suspension to seat mounting plate with (4)
flange locknuts (Fig. 8).
1
Figure 8
1. Seat suspension
5. Mount seat to seat suspension with (4) capscrews,
lockwashers and flatwashers (Fig. 8).
6. Connect seat switch connector to traction unit wire
harness connector.
7. Adjust seat for operator's comfort and weight. To adjust
seat fore and aft, pull handle on left side of seat
assembly outward (Fig. 9). Release handle to lock seat
4
3. Shoulder bolt with washer
and locknut (2)
4. Adjustment handle (2)
Hide quick links:
Advertisement
Table of Contents
