Parking Brake Lever - Toro 22321 Operator's Manual
Compact utility loader
Hide thumbs
Also See for 22321:
- Operator's manual (52 pages) ,
- Operation and safety manual (15 pages) ,
- Quick start quide (2 pages)
Table of Contents
Advertisement
1. Lower the loader arms
2. Raise the loader arms
3. Tilt the attachment
rearward
By moving the lever to an intermediate position (such
as, forward and left), you can move the loader arms and
tilt the attachment at the same time.
Loader Valve Lock
The loader valve lock secures the loader arm/attachment
tilt lever so that you cannot push it forward. This helps
to ensure that no one will accidentally lower the loader
arms during maintenance. Secure the loader arms with
the lock anytime you need to stop the machine with the
loader arms raised.
To set the lock, lift up on it so it clears the hole in
the control panel and swing it to the left in front of
the loader arm lever, pushing it down into the locked
position (Figure 11).
1. Loader valve lock
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in the forward
direction, rotate the auxiliary hydraulics lever rearward
and pull it down to the reference bar (Figure 12, number
1).
Figure 10
4. Tilt the attachment forward
5. Detent (Float) position
Figure 11
2. Loader arm/attachment tilt
lever
To operate a hydraulic attachment in reverse direction,
rotate the hydraulics lever rearward, then move it left
into the upper slot (Figure 12, number 2).
If you release the lever while in the forward position, the
lever will automatically return to the neutral position
(Figure 12, number 3). If it is in the reverse position, it
will remain there until you pull it out of the slot.
1. Forward flow hydraulics
2. Reverse flow hydraulics
Parking Brake Lever
To set the parking brake, push the brake lever forward
and to the left and then pull it rearward (Figure 13).
Note: The traction unit may roll slightly before the
brakes engage in the drive sprocket.
To release the brake, push the lever forward and then
right, into the notch.
Fuel Gauge
This gauge measures the amount of fuel in the fuel tank.
Hydraulic Oil Temperature Light
If the hydraulic oil gets too hot, this light illuminates
and an audible alarm sounds. If this happens, stop the
engine and allow the traction unit to cool.
14
Figure 12
3. Neutral
Figure 13
- Quick Links:
- Controls
- Troubleshooting
- Schematics
Hide quick links:
Advertisement
Table of Contents
