Table of Contents
Advertisement
3. Remove the 3 bolts securing the cover to the clutch and
remove the cover (Fig. 30).
1
Figure 30
1. Cover
4. Thoroughly clean the inside of the cover and the inner
workings of the clutch using compressed air.
Caution
The dust in the clutch will become airborne and
could damage your eyes or you could inhale it
causing breathing difficulties.
Wear safety goggles and a dust mask or other eye
and respiratory protection when performing this
procedure.
5. Lubricate the moving parts in the areas circled in Figure
31 using Toro Dry Lubricant Spray, available through
your Authorized Toro Dealer or Distributor.
Figure 31
6. Install the clutch cover and secure it with the 3 bolts
removed previously.
2
m–6988
2. Bolts
m–6989
27
Servicing the Fuel System
Fuel Lines and Connections
Check lines and connections every 400 hours or yearly,
whichever occurs first. Inspect for deterioration, damage, or
loose connections.
Replacing the Fuel Filter
Replace the fuel filter after every 800 operating hours or
yearly, whichever occurs first.
1. Raise the bed and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to the fuel
lines.
1
Figure 32
1. Fuel filter
4. Install the replacement fuel filter to the fuel lines with
the clamps previously removed. Mount the filter so that
the arrow points toward the carburetor.
Spark Plugs
Replace the spark plugs after every 800 operating hours or
yearly, whichever occurs first, to ensure proper engine
performance and reduce the exhaust emission level.
Type: Champion RC 14YC (or equivalent)
Air Gap: 0.030 in. (0.76 mm)
Note: The spark plug usually lasts a long time; however,
the plug should be removed and checked whenever the
engine malfunctions.
Checking and Replacing the Spark Plug
1. Clean the area around the spark plugs so that foreign
matter cannot fall into the cylinder when the spark plug
is removed.
m–5322
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
