Table of Contents
Advertisement
Figure 24
1. Screw
2. Flange-head bolt
4. Remove the flange-head bolts and nuts from each
skid.
5. Move each skid to the desired position and secure
them with the flange-head bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the skids. The bottom holes are used when
switching sides on a Guardian mower deck, at which
time they become the top holes on the other side
of the mower.
6. Torque the screw at the front of each skid to 80 to
100 in-lb (9 to 11 N⋅m).
Adjusting the Rear Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the rear anti-scalp rollers.
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set the
parking brake.
2. Move the throttle lever to the Slow position, stop
the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. After adjusting the height-of-cut, adjust the rollers
by removing the flange nut, bushing, spacer, and
bolt (Figure 25).
3. Skid
4. Nut
1. Flange nut
2. Bushing
3. Anti-scalp roller
4. Select a hole so the anti-scalp roller is positioned
to the nearest corresponding height-of-cut desired
(Figure 26).
1. 1-1/2 inches (38 mm)
2. 2 inches (51 mm)
5. Install the flange nut bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N⋅m) (Figure 25).
Adjusting the Rollers
Mount the rollers in the lower position when operating
in height of cuts higher than 2-1/2 inches (64 mm) and
in the higher position when operating in height of cuts
lower than 2-1/2 inches (64 mm).
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set the
parking brake.
29
Figure 25
4. Spacer
5. Bolt
Figure 26
3. 2-1/2 inches (63 mm)
4. 3 inches (76 mm) and
higher
- Quick Links:
- Schematics
Hide quick links:
Advertisement
Table of Contents
