Table of Contents
Advertisement
Figure 54
1. Caster Wheel
2. Carrier Frame
3. Front height–of–cut pins
4. Position the blades front-to-rear (Fig. 52). Measure at C
and D locations (Fig. 52) from a level surface to the
cutting edge of the blades (Fig. 53).
5. Check the side-to-side leveling of the cutting unit.
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and traction unit.
2. Position the blades side-to-side (Fig. 55). Measure at A
and B locations (Fig. 55) from a level surface to the
cutting edge of blade tips (Fig. 56).
3. The difference between measurements A and B should
be no more than 1/4 inch (6 mm).
Figure 55
3
2
4
5
1
m–6371
4. Jam nut
5. Ball joint
m–1078
MEASURE FROM
CUTTING EDGE TO
A LEVEL SURFACE
Figure 56
Changing the Side-to-Side
Leveling
Changing the side–to–side leveling is done by adjusting tire
pressure.
Changing the Side–to–Side Leveling with
Tire Pressure
1. Change the tire pressure on both deck and traction unit.
Do this to the corresponding side that needs adjustment.
2. Recheck the front-to-rear pitch and side to side leveling
of the cutting unit.
Matching Height of Cut
1. Check the tire pressure on both deck and traction unit.
2. Set the height-of-cut to the 4 inch (101.6 mm) position
following the height-of-cut decal.
3. With the machine on level surface, position one blade
front-to-rear (Fig. 57). Measure at A and from level
surface to the cutting edge of the blade tips (Fig. 58).
4. The measurement should be 4 inch (101.6 mm).
Figure 57
38
m–2550
m–1078
Advertisement
Table of Contents
