Hydraulic System Maintenance; Servicing The Hydraulic System - Toro 74946 Operator's Manual
With 60in and 72in turbo force side discharge mower
Hide thumbs
Also See for 74946:
- Software manual (17 pages) ,
- Operator's manual (76 pages) ,
- Operator's manual (72 pages)
Table of Contents
Advertisement
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro
or Mobil
®
1 15W-50.
Important: Use oil specified. Other fluids could
damage the hydraulic system.
Each Hydraulic System Oil Capacity: 1.5 L (52 oz) per
side with filter change
Checking the Hydraulic Oil
Service Interval: Every 50 hours—Check the hydraulic oil
level.
1. Position the machine on a level surface.
2. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Wait for the engine and hydraulic system to cool for
10 minutes.
Note: The oil level on the dipstick is incorrect if you
check the oil when the machine is hot.
5. Move the seat forward.
6. Clean the area around the dipsticks of the hydraulic
system reservoirs
(Figure
7. Remove 1 dipstick from the hydraulic reservoir
85).
8. Wipe the dipstick off and thread the dipstick into the
reservoir.
9. Remove the dipstick and look at the end
Note: If the oil level is at the add mark, slowly pour
only enough oil into the hydraulic reservoir to raise the
level to the full or H line.
Important: Do not overfill the hydraulic units
with oil, as damage may occur. Do not run the
machine with the oil below the add mark.
10. Install the dipstick.
11. Repeat procedure for the opposite dipstick.
®
HYPR-OIL
™
500 hydraulic oil
-
position,
EUTRAL
LOCK
85).
(Figure
Either dipstick is used in the machine
1. Full
2. Add
WARNING
Hydraulic oil escaping under pressure can
penetrate skin and cause injury.
• If hydraulic oil is injected into the skin, it
must be surgically removed within a few
(Figure
hours by a doctor familiar with this type
of injury. Gangrene may result if this is
not done.
• Keep your body and hands away from
85).
pin hole leaks or nozzles that eject
high-pressure hydraulic oil.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Make sure that all hydraulic oil hoses and
lines are in good condition and that all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
60
G015459
Figure 85
3. H—means high level
4. Dipstick locations under
seat
Hide quick links:
Advertisement
Table of Contents
