Table of Contents
Advertisement
Figure 15
1. Reverse interlock key
3. Turn the KeyChoice key clockwise until it stops and
release it.
A red light illuminates on the front console (Fig.
NO TAG) to serve as a reminder that the interlock has
been deactivated.
4. Remove the KeyChoice key.
Once you deactivate the interlock, it stays in this
mode—with your mower blade or PTO powered
attachment operating whenever you back up—and the
console light stays on until you either disengage the PTO
or turn off the engine.
Testing the Safety Interlock System
Test the safety interlock system each time before you use
the machine. Do not operate the machine if the safety
system is not functioning properly. If the safety system
does not operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1. Fully press the brake pedal. Pull the PTO switch to the
On position.
2. Turn the ignition key to the Start position. The starter
should not crank.
3. Push the PTO switch to the Off position and release
the brake pedal.
4. Turn the ignition key to the Start position. The starter
should not crank.
5. Fully press the brake pedal and set the parking brake.
Push the PTO switch to the Off position and rise from
the seat.
6. Turn the ignition key to the Start position. The starter
should not crank.
7. Fully press the brake pedal and set the parking brake.
Push the PTO switch to the Off position and start the
engine.
8. With the engine running, release the parking brake and
rise slightly from the seat; the engine should stop.
9. Fully press the brake pedal, set the parking brake, push
the PTO switch to the Off position, and start the
engine.
1
10. Pull the PTO switch to the On position and rise
slightly from the seat; the engine should stop.
11. With the parking brake released, turn the ignition key
to the Run position without starting the engine.
m–4260
12. Pull the PTO switch to the On position; you should
hear an audible click indicating that the PTO is
activated and the PTO light should illuminate.
13. Move the foot pedal to reverse; you should hear an
audible click, indicating that the PTO is deactivated,
and the PTO light should turn off.
14. With the parking brake released, turn the ignition key
to the Run position without starting the engine.
15. Pull the PTO switch to the On position.
16. Turn the KeyChoice key and release it. The
Operating–in–Reverse warning light should illuminate.
17. Move the foot pedal to reverse; the PTO and PTO light
on the dash should remain on.
18. Push the PTO switch to the Off position; the PTO light
and the Operating–in–Reverse warning light should
turn off.
Gauges and Indicator Lights
The indicator lights (Fig. 16) illuminate when certain
controls are activated and when major malfunctions occur
that need immediate attention.
1. Parking brake light
2. PTO (power take off) light
3. Battery light
4. Operating–in–Reverse
warning light
14
1
2
3
4
5
7
8
Figure 16
5. Oil pressure light
6. Cruise control light
7. Engine oil temperature
gauge
8. Fuel gauge
6
m–3317
Hide quick links:
Advertisement
Table of Contents
