Related Manuals for Toro 04472
Summary of Contents for Toro 04472
- Page 1 Form No. 3326-890 8 and 11 Blade SPA Reel Mowers Greensmaster 3250-D Model No. 04472—Serial No. 220000001 and Up Model No. 04473—Serial No. 220000001 and Up Operator’s Manual English (EN, GB)
-
Page 2: Table Of Contents
Part No. 93-4264 additional information, contact an Authorized Service High Cut Bedknife Part No. 94-6392 Dealer or Toro Customer Service and have the model and Fairway Bedknife Part No. 94-6393 serial numbers of your product ready. Figure 1 illustrates the location of the model and serial numbers on the 5 Blade Heavy Duty Reel Part No. -
Page 3: Adjustments
Adjustments 4. Loosen locknuts retaining the left-hand bedbar pivot housing (Fig. 2). 5. Rotate flange nuts (Fig. 2, inset), on top and bottom of Note: Determine the left and right sides of the machine frame tab, clockwise or counterclockwise to raise or from the normal operating position. -
Page 4: Leveling The Front Roller To The Reel
Position 2 Note: A more aggressive setting may be required to compensate for reel wear. (As the reel wears, the cutting Standard position; use for most conditions (factory setting). unit becomes less aggressive). HOC Range: 0.094 (3/32)–0.72 (23/32) in. (2.4–18.3 mm) Leveling the Front Roller to the Note: The top frame hole and top bracket hole will yield Position 2 (standard position). -
Page 5: Adjusting The Top Shield Height
Adjusting the Top Shield profile. Therefore, benchsetting a cutting unit does not equal the effective (actual) height of cut you achieve. You Height need to determine how to adjust your cutter on the bench to achieve a comparable height of cut to a cutting unit of a 1. -
Page 6: Daily Adjustments Of Cutting Unit
Daily Adjustments of Cutting Maintenance Unit Note: Determine the left and right sides of the machine Prior to mowing each day, or as required, each cutting unit from the normal operating position. must be checked to verify proper bedknife-to-reel contact. Greasing the Bearings and This must be performed even though quality of cut is acceptable. -
Page 7: Backlapping The Cutting Units
Note: Additional instructions and procedures on Backlapping are available in the Toro Sharpening Reel & Rotary Mowers Manual, Form No. 80-300PT. Note: For a better cutting edge, run a file across the front face of the bedknife when the lapping operation is completed. -
Page 8: The Toro General Commercial Products Warranty
If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.