Premaintenance Procedures; Raising The Seat; Releasing The Mower-Deck Curtain; Lubrication - Toro 74650 Operator's Manual
Hide thumbs
Also See for 74650:
- Operator's manual (56 pages) ,
- Operator's manual (56 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
Premaintenance
Procedures
Raising the Seat
Make sure that the motion-control levers are locked in the
P
position, and lift the seat forward.
ARK
The following components can be accessed by raising the seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts
•
Fuel filter
•
Battery and battery cables
Releasing the Mower-Deck
Curtain
Loosen the 2 bottom bolts of the curtain to access the top of
the mower deck
(Figure
28).
Figure 28
1. Bottom bolt
Note: Always tighten the bolts to connect the curtain after
maintenance.
2. Curtain
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 general purpose, lithium grease
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
a rag.
Note: Make sure to scrape any paint off of the front
of the fitting(s).
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4. Connect a grease gun to each fitting and pump grease
into the fittings until grease begins to ooze out of the
bearings
(Figure 29
27
(Figure 29
and
Figure
1
G014522
Figure 29
Figure 30
3. Grease every 25 operating
hours
4. Engine
and
Figure
30).
ARK
30) with
- Quick Links:
- Mower Belt Maintenance
- Troubleshooting
- Schematics
Hide quick links:
Advertisement
Table of Contents
