Table of Contents
Advertisement
Picture Menu Operation
Colour temperature
P-NR
Scan mode
Notes:
We recommend that you set the Scan mode to Progressive when viewing a PAL 60 or NTSC transmission.
When viewing a PAL transmission (other than PAL 60) with the Scan mode set to Progressive, the screen will
flicker. This is not a fault.
The Multipip function will not operate when a Progressive signal is used.
Normalisation
Pressing the Normal (
picture settings to the factory preset levels. This is called "Normalisation".
Normalisation will not occur if the Picture Menu is not displayed when the Normal (
The Colour temperature control allows
you to change the White balance setting
between Standard, Warm and Cool.
Use the
or
buttons to switch between
settings.
The P-NR (Picture Noise Reduction)
system is designed to reduce picture
noise during poor quality reception
conditions. Pushing the left or right
buttons will change the setting between
Off, Strong, Weak and Auto.
Use the
or
buttons to switch between
settings.
The Scan mode control allows you to
change the Picture refresh setting
between 75/883i, 100Hz and Progressive.
Use the
or
buttons to switch between
settings.
75/883i
This mode gives a
faster refresh rate and
more lines than a
standard television.
100Hz
100Hz will give a
steady picture for most
signals.
Progressive
Recommended when receiving NTSC signals.
NOTE:
The scan mode function is not available when Picture in Picture
is being used.
Switching is also possible using the
N
) Button on the remote control, when the Picture Menu is displayed will return all
Picture menu
Contrast
Brightness
Colour
Sharpness
Colour Temperature
P-NR
Auto
Scan mode
75 / 833i
Picture menu
Contrast
Brightness
Colour
Sharpness
Colour Temperature
Standard
P-NR
Scan mode
75 / 833i
Picture menu
Contrast
Brightness
Colour
Sharpness
Colour Temperature
Standard
P-NR
Auto
button on the remote control.
) Button is pressed.
Hide quick links:
Advertisement
Table of Contents
