Ez700SR/Ez900HDS COMPONENTS DESCRIPTION SWITCH UNIT (X16-2960-10) Ref. No. Application / Function Operation / Condition / Compatibility LCD Driver Drives LCD Remote Control IC Controls the unit REMO ON SW The power supply of IC2 is turned on when base level goes “L”...
Page 5
Ez700SR/Ez900HDS COMPONENTS DESCRIPTION Ref. No. Application / Function Operation / Condition / Compatibility Q205 Logic reversal ON: IC203, 4 ch1 on / OFF: IC203,4 ch1 off Q206 Control SW ON: IC203 ch1 off / OFF: IC203 ch1 on Q207 DC/DC drive FET...
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION MAIN MICROCOMPUTER : 703030GC053A (X34 : IC101) Truth Pin No. Pin Name Module Application Processing Operation Description Value Table PLL CLK TUNER I/O CLK output terminal to F/E SPAN O SPAN information output terminal L : K destination H : M destination or equivalent...
Page 7
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION Truth Pin No. Pin Name Module Application Processing Operation Description Value Table Power supply control terminal for power CD MECHA+B Power supply I/O ON : L, OFF : Hi-Z supply MP3 SW5V Power supply I/O SW5V control terminal...
Page 8
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION Truth Pin No. Pin Name Module Application Processing Operation Description Value Table LX_REQ_S Request input from external devices Request input pending : L KEY-REQ to PANEL Communication request from LCD driver L : KEY input LO.S SW...
Page 9
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION SUB MICROCOMPUTER : 70F3263GC3T5A or 703262GC301A (X34 : IC501) Truth Pin No. Pin Name Module Application Processing Operation Description Value Table AVREF0 ADC reference voltage Connected to BU+3.3V with H/W. AVSS ADC/DAC GND Connected to GND with H/W.
Page 10
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION Truth Pin No. Pin Name Module Application Processing Operation Description Value Table D/L ALARM D/L function O Alarm LED lightup (When D/L is used.) H : Lightup, L : No lightup BEEP D/L function O BEEP output (When D/L is used.) Test&Debug...
Page 11
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION Truth Pin No. Pin Name Module Application Processing Operation Description Value Table HD Radio Blend signal from IDM Fixed with H/W. HR_7730BLEND HD Radio O Blend signal (output to 7730) H : Digital, L : Analog...
Page 12
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION Truth Value Table Destination Setting SLAVE LOCAL TEST MODE SPECIFICATION TYPE1 TYPE0 Destination Remarks TEST2 TEST1 TEST0 Function Ez900HDS Sirius installed, HD installed. Normal Ez700SR Sirius installed, HD not installed. Sirius TA Mode ON Reserved Debug Mode ON...
Page 13
Ez700SR/Ez900HDS MICROCOMPUTER’S TERMINAL DESCRIPTION r Antenna Detection Method (1) SSM internal circuit is used to detect antenna connection. Sub µ- Normal Condition com makes judgment by a notification from SSP. Terminal setting Signal name Debug terminal TX UART_O H/L (2) Current detection for excess current protection uses the same U_SW L method as KTC-SR902.
• Ez700SR/Ez900HDS Model jump to No. 15. Reset while pressing down Preset y key. This should be (Models with DC error detection function (Ez700SR, done with panel-not-installed and other modes ON. (Reset, Ez900HDS) ACC OFF, power OFF, and momentary power drown do not Audio-related matters clear the test mode.)
Page 15
Ez700SR/Ez900HDS TEST MODE conducted into the following 3 steps : 0 ⇔ 5 ⇔ 10. (Initial Others value : 7) • When q key is pressed, only during internal AUX, 2-ZONE ON/OFF is effected. When ON, P/S dot is turned ON all the Back up current measurement time.
4. If wrong codes were entered, the unit goes into the Code Sirius Function Lock Release mode Request mode. • Ez700SR/Ez900HDS Model 1. While pressing down on Preset t and Disp keys, reset Initializing AUDIO-related value setting (DCERR- to enter the DC Error Display mode. (The Test Mode is related) cleared at this point.)
Ez700SR/Ez900HDS HD RADIO TEST MODE 1. How to Start/End the Test Mode 999. 99 1-1. How to start the test mode While pressing Preset 1 and Preset 3 keys at the same time, press the reset button. Keep on pressing on the Preset keys, until the H/U boots up.
Page 18
Ez700SR/Ez900HDS HD RADIO TEST MODE 3-2-3. Reception mode switching (Ez900HDS only) stopped, which makes normal operation impossible imme- In each band, every time the Preset 5 key is pressed, the re- diately after the adjustment. For normal operation, the unit ception mode is switched in the following manner : Auto →...
Page 19
Ez700SR/Ez900HDS HD RADIO TEST MODE While adjusting these, “1,” “2,” or “3” is displayed and when the 3-3-7. BER measurement (Ez900HDS only) adjustment is successful, the 1 digit will display 1 and when BER information obtained from IDM is displayed.
Page 20
Ez700SR/Ez900HDS ADJUSTMENT Note1) If and when there is more than a minute after turning Calibration on the Fan Operation Temperature the power is turned on a set, wait till the heat sink on the back 1. Objective cools or cool the heat sink using a fan. (Cool to temperature In order to reduce the soiling of the CD mechanism pick, the below 30°C.
Page 21
Ez700SR/Ez900HDS PC BOARD (COMPONENT SIDE VIEW) (FOIL SIDE VIEW) SWITCH UNIT SWITCH UNIT X16-2960-10 (J76-0036-12) X16-2960-10 (J76-0036-12) X16-2960-10 X16-2960-10 Ref. No. Address Ref. No. Address C12 C13 Refer to the schematic diagram for the values of resistors and capacitors.
Page 22
Ez700SR/Ez900HDS PC BOARD (COMPONENT SIDE VIEW) ELECTRIC UNIT X34-3340-1x (J76-0031-12) A301 C261 C242 W301 C222 I G O IC202 C404 C339 IC207 C321 C433 C420 C403 L309 C434 C266 R421 IC402 C370 C317 C304 C428 IC301 C303 W501 C424 IC501...
Page 24
Ez700SR/Ez900HDS PC BOARD (FOIL SIDE VIEW) ELECTRIC UNIT X34-3340-1x (J76-0031-12) C31 R53 Q227 A-8V C241 C320 C319 C203 C343 C342 R279 BU3.3V D D D D C238 3.3V R555 C279 S G S R282 C280 D D D D S G S I1.8V...
Page 26
Ez700SR/Ez900HDS PC BOARD (COMPONENT SIDE VIEW) CD PLAYER UNIT X32-5540-02 (J74-1602-12) CP12 CP13 CP15 MIACK X32-5540-02 Ref. No. Address Refer to the schematic diagram for the values of resistors and capacitors.
Page 27
Ez700SR/Ez900HDS PC BOARD (FOIL SIDE VIEW) CD PLAYER UNIT X32-5540-02 (J74-1602-12) Vref FLAG HOLD MIRR LOCK TRK IN TRK OUT FCS DOWN FCS UP C22 C23 D3.3V BCKIA SDIO 12EJE A.+8V LRCKIA /EJECT SLED IN SLED OUT A.GND /LOAD DATA SPDL- BU2.5V...
Page 28
Ez700SR/Ez900HDS (X34-3340-1x) (E30-6363) SUB WOOFER R LX BUS SUB WOOFER GND WOOFER SUB WOOFER L (E30-6370) 4.7K FRONT R FRONT GND FRONT FRONT L 4.7K REAR R REAR REAR GND REAR L 4.7K LX-REQ-M LX-RST AUX IN R 0.47 CH-R B.U.
Page 33
Values m a y v a r y slightly due to I-1.8V variations be- I-3.3V t w e e n i n d i - vidual instru- ments or/and units. Ez700SR/Ez900HDS (1/2) X34-3340-1x (6/6)
Page 34
Ez700SR/Ez900HDS SWITCH UNIT (X16-2960-10) ED1(SEGMENT) ED1(COMMON) ESD-GND FLIP DET TP13 RESET S14 RESET VOL A D GND+ILL GND VOL B ILL+B DIMMER REMOTE CONTROL IC TP11 TP19 REMO OUT GND TP21 CP2 470 TP10 TP23 REMOTE TP25 CONTROL TP12 TP27...
Page 35
DTC124EUA DTC144EUA DAN202U TA78L05F-F AUTO DAP202U DISP DA204U DTA114YUA AUDIO TC7SH08FU GREEN TA48M033F-F Ez700SR/Ez900HDS (2/2) LC75808W-E RS-171 DTA114EE Q3-5 2SC4617 B30-1566-05 D2,3 B30-1698-05 MAZS0820L CAUTION : For continued safety, replace safety critical components D22-29 UDZS6.2B only with manufacturer's recommended parts (refer to parts list).
Installation Size (W x H x D) ....178 x 50 x 165mm ............7 x 1-15/16 x 6-1/2inch Weight ............. 3.1lbs (1.4kg) KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. KENWOOD CORPORATION 2967-3, Ishikawa-machi, Hachioji-shi, Tokyo, 192-8525 Japan KENWOOD USA CORPORATION KENWOOD ELECTRONICS ITALIA S.p.A.