Huawei SmartAX MA5603T Configuration Manual page 164

Access module

Hide thumbs Also See for SmartAX MA5603T:

Table of Contents

SmartAX MA5600T/MA5603T/MA5608T Multi-service

Access Module

Commissioning and Configuration Guide

Issue 01 (2014-04-30)

Commission the outband network management on the U2000.

Configure the gateway of the route from the U2000 to network segment 10.50.1.0/24

to 10.10.1.1.

– In the Solaris OS, do as follows:

Run the route add 10.50.1.0 10.10.1.1 command to add a route.

Run the netstat -r command to query the information about the current routing

– In the Windows OS, do as follows:

Run the route add 10.50.1.0 mask 255.255.255.0 10.10.1.1 command to add a

Run the route print command to query the information about the current routing

If the IP address of the outband network management port and the IP address of the U2000 are

in the same network segment, you need not configure the routing information.

Set the SNMP parameters. A default SNMP profile exists in the system. Use the default

profile in this service. If a new profile is required, do as follows:

Choose Administration > NE Communicate Parameter > Default Access

Protocol Parameters from the main menu.

– When the SNMP V1 is used, choose SNMP v1 Parameter on the Default

Access Protocol Parameters tab page. Then click Add and set the SNMP

parameters, as shown in the following figure (the other parameters except

Profile name use the default settings).

Figure 1-51 Set the SNMP parameters

– When the SNMP V2 is used, choose SNMP v2 Parameter on the Default

Access Protocol Parameters tab page. Then click Add and set the SNMP

parameters, as shown in the following figure (the other parameters except

Profile name use the default settings).

Huawei Proprietary and Confidential

1 Commissioning

Show Quick Links

Table of Contents

Smartax ma5600t Smartax ma5608t