Table of Contents
Advertisement
Display
D
N flashes
:
.
Other displays
Faults and what to do about them
Faults
Water is leaking out.
No water supply.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
emptied.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
Cause/remedial action
The childproof lock is activated; to deactivate:
Too much foam detected, a rinse cycle has been switched on.
The mains voltage is too low. ~ Page 27
Undervoltage in the wash programme. The programme is extended. ~ Page 35
Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-
play appears again, call the after-sales service. ~ Page 35
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Reload A not pressed?
■
Tap not turned on?
■
Filter blocked? Clean the filter. ~ Page 31
■
Note:
If an additional water filter has been installed (depending on model)
~ Page 11, check for contaminants and clean if required ~ separate
installation and cleaning instruction for water filter.
Supply hose kinked or trapped?
■
Safety function active.
■
Note:
For safety reasons, the washing machine door remains locked when
the water level or temperature is high (See ~ Cancel the programme ) or
while the drum is rotating.
Is the D Childproof lock activated? To deactivate: ~ "Childproof lock"
■
on page 25
– – – 0 (Rinse hold = without final spin) selected?
■
Can the door be opened by emergency release only?
■
Start/Reload A pressed or Ready in ð time selected?
■
Washing machine door closed?
■
Is the D Childproof lock activated? To deactivate: ~ "Childproof lock"
■
on page 25
– – – 0 (Rinse hold = without final spin) selected?
■
Clean the detergent solution pump. ~ Page 30
■
Clean the waste pipe and/or drainage hose. ~ Page 30
■
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute large and small items of laundry evenly in the drum.
Spin speed selected too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Faults and what to do about them
en
33
Advertisement
Table of Contents
