Configuring A Secondary Root Bridge - Cisco Nexus 6000 Series Configuration Manual
Nx-os layer 2 guide
Hide thumbs
Also See for Nexus 6000 Series:
- Installation manual (86 pages) ,
- Reference manual (12 pages) ,
- Configuration manual (216 pages)
Table of Contents
Advertisement
Configuring Rapid PVST+
With the switch configured as the root bridge, do not manually configure the hello time, forward-delay
Note
time, and maximum-age time using the spanning-tree mst hello-time, spanning-tree mst forward-time,
and spanning-tree mst max-age configuration commands.
Procedure
Step 1
Step 2
This example shows how to configure the switch as the root bridge for a VLAN:
switch# configure terminal
switch(config)# spanning-tree vlan 5 root primary diameter 4
Configuring a Secondary Root Bridge
When you configure a software switch as the secondary root, the STP bridge priority is modified from the
default value (32768) so that the switch is likely to become the root bridge for the specified VLANs if the
primary root bridge fails (assuming the other switches in the network use the default bridge priority of 32768).
STP sets the bridge priority to 28672.
Enter the diameter keyword to specify the network diameter (that is, the maximum number of bridge hops
between any two end stations in the network). When you specify the network diameter, the software
automatically selects an optimal hello time, forward delay time, and maximum age time for a network of that
diameter, which can significantly reduce the STP convergence time. You can enter the hello-time keyword
to override the automatically calculated hello time.
You configure more than one switch in this manner to have multiple backup root bridges. Enter the same
network diameter and hello time values that you used when configuring the primary root bridge.
With the switch configured as the root bridge, do not manually configure the hello time, forward-delay
Note
time, and maximum-age time using the spanning-tree mst hello-time, spanning-tree mst forward-time,
and spanning-tree mst max-age global configuration commands.
Command or Action
switch# configure terminal
switch(config)# spanning-tree vlan
vlan-range root primary [diameter
dia [hello-time hello-time]]
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
Configuring a Secondary Root Bridge
Purpose
Enters global configuration mode.
Configures a software switch as the primary root bridge.
The vlan-range value can be 2 through 4094 (except
reserved VLAN values.) The dia default is 7. The
hello-time can be from 1 to 10 seconds, and the default
value is 2 seconds.
61
Advertisement
Table of Contents
