For further information, see the User Manual. Moving and Carrying Notice Moving Notice: Please contact HITACHI directly if you Moving the monitor requires at least four people. If not, it may drop and a serious have questions on the use of the touch injury may result.
2 Package contents Unpacking Don‘t place objects on the touch monitor. If the touch monitor is covered or the vents are blocked, the monitor could overheat and cause a fire. The e-Screen is packed in a cardboard box and may be banded ...
3 Installation Power Input Signal Source Input Power Cord In/Output Interface The power cord, included, is used to connect the LCD monitor and the wall socket. RS232C Connect the power cord into main power socket of the monitor. Speaker out USB 2.0 OSD 7Key USB 3.0...
Important Notice Turning the monitor on The USB cable (5 m) that Hitachi provides in this accessory box is 1. Correctly insert the power cord into the monitor and for use of connection to Touch USB at the back. Therefore, in case...
Touch Operation No calibration is required for first-time use. However, the touch system might need calibration over time or when for instance a different resolution is used. Please find calibration instructions below for the different operating systems: Installation: 1. Connect the signal cable to the monitor and then turn on the monitor.
5 Troubleshooting 6 Compliance and regulatory information FCC Compliance Statement: Before calling service personnel, please check the following chart for a possible cause to the trouble you are experiencing. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC ...