PIONEER Service Manual. A subscription to, or additional copies Also test with plug reversed of, PIONEER Ser vice Manual may be obtained at a (Using AC adapter Earth nominal charge from PIONEER. plug as required)
Page 3
By following the instructions in this manual, be sure to apply the prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed ones should be used. S-DV900SW...
For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions, apply as you think it appropriate.) 2.1 PACKING POWERED SUBWOOFER (1/2) (2/2) FAN COVER S-DV900SW...
2.2 PRODUCT APPEARANCE SECTION [POWERD SUBWOOFER] RED (-) RED (+) BLACK (+) BLACK (-) CIRCUIT DIAGRAM FOR SP BLACK Refer to "2.3 AMPLIFIER ASSY". S-DV900SW...
• The > mark found on some component parts indicates the importance of the safety factor of the part. Therefore, when replacing, be sure to use parts of identical designation. • : The power supply is shown with the marked box. S-DV900SW...
3.4 POWER ASSY CAUTION : FOR CONTINUED PROTECTION AGAINST 38.43V RISK OF FIRE. REPLACE ONLY WITH SAME TYPE NO. 491005 MFD, BY LITTELFUSE INK. FOR IC3051. (FL) -39.21V 24.784V 14.66V 12.112V -25.513V (SL) 15.883V (SW) (SW) (SW) CN3707 CN3706 CN3703 S-DV900SW...
Page 19
: SW ch AUDIO SIGNAL ROUTE (FL) (FL) (FL) (SL) (SL) (SL) : Refer to "7.1.1 PROTECTION CIRCUIT" (SW) (SW) (SW) (SW) (SW) • NOTE FOR FUSE REPLACEMENT FOR CONTINUED PROTECTION AGAINST RISK OF FIRE. CAUTION - REPLACE WITH SAME TYPE AND RATINGS ONLY. S-DV900SW...
Page 21
PRIMARY ASSY (DAXJI: AWU8030) • NOTE FOR FUSE REPLACEMENT FOR CONTINUED PROTECTION AGAINST RISK OF FIRE. CAUTION - REPLACE WITH SAME TYPE AND RATINGS ONLY. S-DV900SW...
Symbol In PCB Symbol In Schematic Part Name Diagrams Diagrams C E B Capacitor Connector Transistor B C E SIDE A Transistor with resistor B C E Field effect SIDE B P.C.Board Chip Part transistor Resistor array 3-terminal regulator S-DV900SW...
4.3 POWER ASSY SIDE A POWER ASSY To Power Transformer CN3703 CN11 CN3052 OPEN SIDE CN3053 OPEN SIDE CN3053 IC41 IC33 IC3052 Q3606 IC3051 CN51 S-DV900SW...
Page 29
SIDE A CN3706 CN3707 CN3054 CN3051 OPEN SIDE PRODUCTION CODE PEN SIDE (ANP7432-D) Q3606 IC3051 Q3608 Q3614 S-DV900SW...
YPW ONLY W187 W187,W188 DFL,YPW ONLY Except YPW W165 W166 PRIMARY DFL ONLY W133 W134 YPW ONLY W101,W102 W371 DFL ONLY W370 W114,W115 These knob position is Except YPW (S101 and S102) W115 240V W114 S101 S102 (ANP7432-D) AC IN S-DV900SW...
Page 33
AWU8004 AWU8030 AWU8045 CAUTION REPLACE WITH SAME TYPE AND RATINGS OF FUSE ATTENTION REMPLACER PAR LE FUSIBLE PAR UN MODELE INDENTIQUE EN INTENSITE PRIMARY 110 - 120V 220 - 230V 240V 110 - 120V 220 - 230V 240V (ANP7432-D) S-DV900SW...
VP+8 falls to GND level because of short-circuit, etc., Q106 is turned on, and the level of the XPROTECT line becomes low. ← The microcomputer detects the XPROTECT level and shuts the power to the unit off. S-DV900SW...
Page 39
Q3606 (E, C, B) is turned on, and the level of XPROTECT becomes low. → The microcomputer detects the XPROTECT level and shuts the power to the unit off. (2) When negative (-) DC voltage was generated at the SP terminal Q3604 is turned on, and XPROTECT is activated. S-DV900SW...
1) The cosmetic baffle, those screws are removed when removing the cosmetic duct attached in cosmetic baffle with four screws. 5. Diagnosis 1) Remove the four screws 3. 2) Disconnect the two connectors 4. 3) Remove the AMP MODULE 5. AF Assy AMP MODULE 6CH S-DV900SW...
Page 41
4) Connect the two jig cables as figure below. Jig Cable (GGD1315) PRIMARY Assy AF Assy POWER Assy AMP MODULE 6CH Diagnosis S-DV900SW...
Control relay for rear and center speaker SPRYS Control relay for front speaker 7.3 CLEANING Before shipping out the product, be sure to clean the following positions by using the prescribed cleaning tools: Position to be cleaned Cleaning tools Fans Cleaning paper : GED-008 S-DV900SW...