Toro 20381 Operator's Manual

Hide thumbs Also See for 20381:

Operator's manual (24 pages)

Operator's manual (28 pages)

Operator's manual (25 pages)

Table Of Contents

Table of Contents

Quick Links

Introduction

This rotary-blade, walk-behind lawn mower is intended to

be used by residential homeowners. It is designed primarily

for cutting grass on well-maintained lawns on residential

properties. It is not designed for cutting brush or for

agricultural uses.

Read this information carefully to learn how to operate and

maintain your product properly and to avoid injury and

product damage. You are responsible for operating the

product properly and safely.

You may contact Toro directly at www.Toro.com for product

and accessory information, help finding a dealer, or to register

your product.

Whenever you need service, genuine Toro parts, or additional

information, contact an Authorized Service Dealer or Toro

Customer Service and have the model and serial numbers of

your product ready.

Figure 1

model and serial numbers on the product.

g026368

1. Model and serial number plate

Write the product model and serial numbers in the space

below:

Model No.

Serial No.

This manual identifies potential hazards and has safety

messages identified by the safety-alert symbol

which signals a hazard that may cause serious injury or death

if you do not follow the recommended precautions.

8111 Lyndale Avenue South

Bloomington, MN 55420

identifies the location of the

Figure 1

(Figure

Lawn Mower

1. Safety-alert symbol

This manual uses 2 words to highlight information.

Important calls attention to special mechanical information

and Note emphasizes general information worthy of special

attention.

This product contains a chemical or chemicals

known to the State of California to cause cancer,

birth defects, or reproductive harm.

The engine exhaust from this product

contains chemicals known to the State of

California to cause cancer, birth defects,

or other reproductive harm.

It is a violation of California Public Resource Code

Section 4442 or 4443 to use or operate the engine on any

forest-covered, brush-covered, or grass-covered land unless

the engine is equipped with a spark arrester, as defined in

Section 4442, maintained in effective working order or the

engine is constructed, equipped, and maintained for the

prevention of fire.

g026368

This spark ignition system complies with Canadian ICES-002.

Net Torque: The gross or net torque of this engine was

laboratory rated by the engine manufacturer in accordance

with the Society of Automotive Engineers (SAE) J1940.

As configured to meet safety, emission, and operating

requirements, the actual engine torque on this class of mower

will be significantly lower. Go to www.Toro.com to view

specifications on your mower model.

Important: If you are using this machine above 1500 m

(5,000 ft) for a continuous period, ensure that the High

Altitude Kit has been installed so that the engine meets

CARB/EPA emission regulations. The High Altitude

Kit increases engine performance while preventing

2),

spark-plug fouling, hard starting, and increased

emissions. Once you have installed the kit, attach

the high-altitude label next to the serial decal on the

Form No. 3408-875 Rev A

Operator's Manual

Figure 2

WARNING

CALIFORNIA

Proposition 65 Warning

Original Instructions (EN)

Printed in the USA

g000502

Table of Contents

Summary of Contents for Toro 20381

Page 1: Introduction
Note emphasizes general information worthy of special product damage. You are responsible for operating the attention. product properly and safely. WARNING You may contact Toro directly at www.Toro.com for product and accessory information, help finding a dealer, or to register CALIFORNIA your product. Proposition 65 Warning...
Page 2: Table Of Contents
Cleaning under the Machine........16 label for your machine. To locate a dealer convenient to Folding the Handle ..........16 you, access our website at www.Toro.com or contact our Maintenance ..............18 Toro Customer Care Department at the number(s) listed Recommended Maintenance Schedule(s) ......18 in your Emission Control Warranty Statement.
Page 3: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decaloemmarkt Manufacturer's Mark 1. Indicates the blade is identified as a part from the original machine manufacturer.
Page 4 decal115-8411 115-8411 1. Unlocked 2. Locked decal117-2718 117-2718 decal132-4470 decal131-4514b 132-4470 131–4514 Traction Adjustment 1. Warning—read the Operator's Manual. 1. Attention; read the 2. Scan the QR code for 2. Cutting/dismemberment hazard of hand or foot, mower Operator's Manual—1) more information on blade—stay away from moving parts;...
Page 5: Setup
Setup Important: Remove and discard the protective plastic sheet that covers the engine and any other plastic or wrapping on the machine. Important: To prevent accidental starting, do not insert the electric-start button into the electric starter switch until you are ready to start the engine. G017457 g017457 Figure 4...
Page 6: Installing The Recoil-Starter Rope In The Rope Guide
Installing the Recoil-starter Rope in the Rope Guide No Parts Required Procedure Important: To start the engine safely and easily whenever you use the machine, install the recoil-starter rope in the rope guide. Hold the blade-control bar to the upper handle and pull the g186624 Figure 7 recoil-starter rope through the rope guide on the handle...
Page 7: Assembling The Grass Bag
Assembling the Grass Bag No Parts Required Procedure 1. Slip the grass bag over the frame as shown in Figure g027257 g027257 Figure 8 g027258 g027258 Figure 9 1. Handle 3. Grass bag 2. Frame 3. Hook the top and side channels of the bag onto the top Note: Do not slip the bag over the handle and sides of the frame, respectively (Figure...
Page 8: Product Overview
Product Overview Operation Before Operation Before Operation Safety General Safety • Become familiar with the safe operation of the equipment, operator controls, and safety signs. • Check that all guards and safety devices, such as deflectors and/or grass catcher, are in place and working properly. •...
Page 9: Filling The Fuel Tank
Filling the Fuel Tank • For best results, use only clean, fresh, unleaded gasoline with an octane rating of 87 or higher ((R+M)/2 rating method). • Oxygenated fuel with up to 10% ethanol or 15% MTBE by volume is acceptable. •...
Page 10: Adjusting The Cutting Height
• Use accessories and attachments approved by the The Toro® Company only. Slope Safety • Mow across the face of slopes; never up and down. Use extreme caution when changing direction on slopes.
Page 11: Starting The Engine
Starting the Engine Note: If the machine does not start after several attempts, contact an Authorized Service Dealer. You can start the engine using either the electric-start button or the recoil-start handle. Starting the Engine Using the Recoil-Start Handle Starting the Engine Using the Electric-Start Button 1.
Page 12: Using The Self-Propel Drive
Using the Self-Propel Drive To operate the self-propel drive, simply walk with your hands on the upper handle and your elbows at your sides, and the machine will automatically keep pace with you (Figure 20). g007288 Figure 21 1. Rear door 2.
Page 13: Bagging The Clippings
Bagging the Clippings Use the grass bag when you want to collect grass and leaf clippings from the lawn. If the side-discharge chute is on the machine, remove it and lock the side-discharge door; refer to Removing the Side-Discharge Chute (page 15).
Page 14 Note: To unlock the plug, rotate the lever on the plug to the right (Figure 28). 5. Lower the rear door. Side-Discharging the Clippings If the bag is on the machine, remove it and insert the rear plug; refer to Removing the Grass Bag (page 13).
Page 15: Operating Tips
(electric-start model only), and examine the machine for damage. • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade.
Page 16: After Operation
After Operation After Operating Safety General Safety • Clean grass and debris from the machine to help prevent fires. Clean up oil or fuel spills. • Allow the engine to cool before storing the machine in g189103 Figure 34 any enclosure. 1.
Page 17 3. To unfold the handle, refer to 1 Assembling and Unfolding the Handle (page g186627 Figure 35 1. Electric starter 2. Electric-start button 2. Rotate the handle forward (Figure 36). Important: Route the cables to the outside of the handle knobs as you fold the upper handle. g189128 Figure 36...
Page 18: Maintenance
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •...
Page 19: Replacing The Air Cleaner
Replacing the Air Cleaner Changing the Engine Oil Service Interval: Yearly Service Interval: After the first 5 hours 1. Press down on the latch tabs on top of the air-cleaner Yearly cover (Figure 38). Engine oil capacity: 0.5 L (19 fl. oz) Oil viscosity: SAE 30 or SAE 10W-30 detergent oil API service classification: SJ or higher Note: Run the engine a few minutes before changing the...
Page 20: Charging The Battery
8. Wipe the dipstick clean with a clean cloth. 9. Insert the dipstick into the oil-fill tube, then remove the dipstick. 10. Read the oil level on the dipstick (Figure 40). g189390 Figure 42 2. Plug the charger into a wall outlet. g186624 Figure 41 Note: When the battery no longer holds a charge,...
Page 21: Lubricating The Wheel Gears
Replacing the Blade Service Interval: Yearly Important: You will need a torque wrench to install the blade properly . If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer. Examine the blade whenever you run out of fuel. If the blade is damaged or cracked, replace it immediately.
Page 22: Adjusting The Self-Propel Drive
Adjusting the Self-Propel Drive Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive. 1. Turn the adjustment knob counterclockwise to loosen the cable adjustment (Figure 47). g005455 g027231 Figure 46 Figure 47 1.
Page 23: Storage
Storage 1. On the last refueling of the year, add fuel stabilizer (such as Toro Premium Fuel Treatment) to the fuel. 2. Dispose of any unused fuel properly. Recycle it according to local codes, or use it in your automobile.
Page 24 Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.

This manual is also suitable for:

Super recycler 20384

Toro 20381 Operator's Manual

Quick Links

Introduction

Related Manuals for Toro 20381

Summary of Contents for Toro 20381

This manual is also suitable for:

Table of Contents