Assignment Of The Feedback And Control Interface For The Count Modes; Table 2-3 Feedback Interface (Inputs) - Siemens SIMATIC ET 200S Operating Instructions Manual
Technological functions
Hide thumbs
Also See for SIMATIC ET 200S:
- Manual (652 pages) ,
- Operating instructions manual (418 pages) ,
- Hardware installation and operating manual (216 pages)
Table of Contents
Advertisement
1Count24V/100kHz
2.6 Count Modes
2.6.10
Assignment of the Feedback and Control Interface for the Count Modes
Note
The following data of the control and feedback interfaces are consistent for the
1Count24V/100kHz:
Bytes 0 to 3
Bytes 4 to 7
Bytes 8 to 11 (modified user data interface)
Use the access or addressing mode for data consistency over the entire control and
feedback interface on your master (only for configuration using the GSD file).
Assignment Tables
Table 2-3
Feedback Interface (Inputs)
Address
Assignment
Bytes 0 to 3
Count value or stored count value in the case of the latch function on the digital input
Byte 4
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Byte 5
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
46
Short circuit of the encoder supply
Short circuit / wire break / overtemperature
Parameter assignment error
Reserve = 0
Reserve = 0
Resetting of status bits active
Load function error
Load function is running
Down direction status
Up direction status
Reserve = 0
DO2 status
DO1 status
Reserve = 0
DI status
Internal gate status
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
Designation
ERR_24V
ERR_DO1
ERR_PARA
RES_STS_A
ERR_LOAD
STS_LOAD
STS_C_DN
STS_C_UP
STS_DO2
STS_DO1
STS_DI
STS_GATE
Hide quick links:
Advertisement
Table of Contents
