Table of Contents
Advertisement
Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456
5.8.2 Configure Power Failure Recovery Mode
----
Power Recovery
Last
Manual
Auto
----
Power Rec. Mode
50. 0
%
Default Output
Power Recovery
46
Power Failure Recovery Mode
When power to the analyzer is restored,
according to the Power Failure Recovery Mode selected in this frame.
Select the required mode:
Auto
Manual
Last
Default Output
Set the default output required after Power Failure Recovery, between 0 and 100% in
0.1% increments.
Note. A setting of 0% represents no output.
Return to main menu.
CONFIG. CONTROL
See Section 5.9.
CONFIG. SECURITY
Control Mode
-
is set to
Control Mode
Auto
power failure.
-
is set to
Control Mode
Manual
power failure.
Control Output
the
frame below.
Default Output
-
and
Control Mode
Control Output
set prior to the power failure.
5 PROGRAMMING
(Section 2.3) is set automatically
irrespective of its setting prior to the
irrespective of its setting prior to the
(Section 2.3) is set to the level set in
are set to the same state as that
IM/AX4CO
Issue 11
- Quick Links:
- System Description
- Sensor Calibration
Hide quick links:
Advertisement
Table of Contents
