Installing A Dc Power Supply - Cisco PIX 501 Hardware Installation Manual
Pix series
Hide thumbs
Also See for PIX 501:
- Quick start manual (21 pages) ,
- User and installation manual (156 pages) ,
- Datasheet (8 pages)
Table of Contents
Advertisement
Chapter 6
PIX 525
The Gigabit Ethernet circuit board and the fiber optic cable connection are shown in
Figure 6-19 Gigabit Ethernet Circuit Board
The Gigabit Ethernet circuit board has three LEDs:
•
•
•
Installing a DC Power Supply
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC
circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit
breaker in the OFF position.
Complete these steps to install the DC power supply:
Place the power supply as shown in
Step 1
to feel the chassis hook engage with the slot on the bottom of the power supply.
Reinstall the three screws that secure the power supply on the back panel of the chassis.
Step 2
78-15170-01
TX—Transmitting data
RX—Receiving data
LINK—The Gigabit Ethernet circuit board has established a network connection
TX
RX
LIN K
Figure
6-20, and then slide it toward the rear panel. You will be able
Cisco PIX Firewall Hardware Installation Guide
Installing a DC Power Supply
Figure
6-19.
6-19
- Quick Links:
- Pix 501 Product Overview
Hide quick links:
Advertisement
Table of Contents
