hit counter script

Installing The Pix 515/515E - Cisco PIX 501 Hardware Installation Manual

Pix series
Hide thumbs Also See for PIX 501:
Table of Contents

Advertisement

Chapter 4
PIX 515/515E
Figure 4-4
Figure 4-4
Table 4-2
Table 4-2
LED
100 Mbps
LINK
FDX
The inside or outside network connections can be made to any available interface port on the
PIX 515/515E. If you are only using the ETHERNET 0 and ETHERNET 1 ports, connect the inside
network cable to the interface connector marked ETHERNET 0 or ETHERNET 1. Connect the outside
network cable to the remaining Ethernet port.
The USB port to the left of the Console port is not used. The detachable plate above the ETHERNET 1
connector is also not used.

Installing the PIX 515/515E

This section contains the following topics:
78-15170-01
shows the PIX 515/515E rear panel LEDs.
PIX 515/515E Rear Panel
100 Mbps
100 Mbps
LED
FDX
LINK
LED
LED
100 Mbps
Link
FDX
10/10 0 ETHE RNET 1
10/100BaseTX
ETHERNET 1
(RJ-45)
lists the state of the PIX 515/515E rear panel LEDs.
PIX 515/515E Rear Panel LEDs
Status
Light On
Light On
Light On
Light Off
Surface Mounting the PIX 515/515E, page 4-4
Rack Mounting the PIX 515/515E, page 4-4
Vertical Mounting the PIX 515/515E, page 4-5
Installing a Circuit Board in the PIX 515/515E, page 4-17
LED
LINK
FDX
LED
LED
FAILOV ER
100 Mbps
Link
FDX
10/10 0 ETHE RNET 0
CON SOLE
10/100BaseTX
Console
ETHERNET 0
port (RJ-45)
(RJ-45)
Description
100 megabits per second 100BaseTX communication. If the
light is off, that port is using 10 megabits per second data
exchange.
Shows that data is passing on the network to which the
connector is attached.
Shows that the connection uses full duplex data exchange
where data is transmitted and received simultaneously.
If this light is off, half-duplex is in effect.
Cisco PIX Firewall Hardware Installation Guide
Installing the PIX 515/515E
Power switch
4-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents