Advertisement
Quick Links
IBM storage products
Quick installation guide
Ultrastar 9ES
Multimode SE/LVD
Models: DDRS-39130 DDRS-34560
Handling precautions
Ÿ
Do not open the electrostatic discharge (ESD) bag
containing the drive until required.
Ÿ
Do not apply pressure on the drive during handling
or installation.
Ÿ
To prevent damage from impact or vibration always
set the drive down gently.
Ÿ
Handle the drive carefully by the edges. Do not
touch the exposed printed circuit board or any
electronic components.
Ÿ
Do not press on the top or bottom of the drive.
Ÿ
Do not cover the breather hole! Covering the
breather hole may result in loss of data.
Ÿ
Save the packaging materials including the ESD
bag in the event that the drive must be returned.
Installing the drive
This guide provides instructions for the installation of a
multimode SE/LVD hard disk drive.
Backup all data.
1.
Record the serial number and part number of your
2.
hard drive for future reference.
Turn off the computer and remove the computer
3.
system cover.
4.
Before handling the hard disk drive, discharge any
static electricity from you and your clothing. With
one hand touch an unpainted metal surface on your
computer chassis, then touch the ESD bag with the
other hand for a minimum of two seconds. Remove
the ESD bag from the hard drive.
Unplug the computer.
5.
1
PLEASE NOTE: If the Ultrastar multimode SE/LVD
drive is attached to a SCSI bus with SE device(s), the
drive operates in SE mode without installing the forced
SCSI SE mode jumper.
IBM Hard Disk Drive Technical Support Center
1
Assign a SCSI address to the drive. Address 7 is
6.
normally reserved for the SCSI controller. Refer to
the illustration below, install the appropriate
jumper(s) on the Option Jumper Block.
Electronic
Component
Side
Option Jumper
Block
Refer to the following illustration to select desired
7.
option(s) and install the appropriate jumpers.
Page 1
SCSI Address
Pin Location
Address 0
Address 8
Address 1
Address 9
Address 2
Address 10
Address 3
Address 11
Address 4
Address 12
Address 5
Address 13
Address 6
Address 14
Address 7
Address 15
version 3.0
Advertisement
Related Manuals for IBM Ultrastar 9ES
Summary of Contents for IBM Ultrastar 9ES
-
Page 1: Quick Installation Guide
PLEASE NOTE: If the Ultrastar multimode SE/LVD drive is attached to a SCSI bus with SE device(s), the drive operates in SE mode without installing the forced SCSI SE mode jumper. Page 1 IBM Hard Disk Drive Technical Support Center version 3.0... - Page 2 Questions regarding IBM’s warranty terms or methodology used to IBM Hard Disk Drive Technical Support Center. derive this data should be referred to the IBM Hard Disk Drive Technical Support Center. Data subject to change without notice.