Advertisement
Table of Contents
SUPPLEMENT OF
SUPPLEMENT OF
SUPPLEMENT OF
SUPPLEMENT OF
SUPPLEMENT OF
SERVICE MANUAL
SER
SER
VICE MANUAL
VICE MANUAL
VICE MANUAL
SER
SER
VICE MANUAL
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE TO
(a) Do not operate or allow the oven to be operated with the door open.
(b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs as necessary :
(1) Interlock operation, (2) proper door closing, (3) seal and sealing surfaces (arcing, wear, and other damage),
(4) damage to or loosening of hinges and latches, (5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection within the microwave generating
compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity,
and connections.
(d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and
transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before
the oven is released to the owner.
(e) A microwave leakage check to verify compliance with the Federal performance standard should be performed
on each oven prior to release to the owner.
Micr
Microwave Oven
Micr
owave Oven
owave Oven
owave Oven
Micr
Micr
owave Oven
W W W W W ARNING TO SER
ARNING TO SER
ARNING TO SER
ARNING TO SER
ARNING TO SERVICE TECHNICIANS
EXCESSIVE MICROWAVE ENERGY
Pr Pr Pr Pr Product Code No.
oduct Code No.
oduct Code No.
oduct Code No.
oduct Code No.
See the Service Manual of EM-P672WS (SM-860245)
except the items described in this Service Manual.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
VICE TECHNICIANS
VICE TECHNICIANS
VICE TECHNICIANS
VICE TECHNICIANS
File No :
File No :
File No :
File No :
File No :
EM-P842WS (U.S.A.)
EM-P842WS (U.S.A.)
EM-P842WS (U.S.A.)
EM-P842WS (U.S.A.)
EM-P842WS (U.S.A.)
437 480 04
437 480 04
437 480 04
437 480 04
437 480 04
REFERENCE NO. SS-860262
Advertisement
Table of Contents
Related Manuals for Sanyo EM-842WS
Summary of Contents for Sanyo EM-842WS
-
Page 1: Excessive Microwave Energy
(e) A microwave leakage check to verify compliance with the Federal performance standard should be performed on each oven prior to release to the owner. Micr Micr Microwave Oven owave Oven owave Oven owave Oven Micr... - Page 2 If a microwave oven is found to operate with the door open, report to Dept. of Service, the manufacturer and CDRH* that...
-
Page 3: Power Output Measurement
Specifications ... Power Output Measurement ... Circuit Diagram ... 1. SPECIFICATIONS 1. SPECIFICA 1. SPECIFICA 1. SPECIFICA 1. SPECIFICA TIONS TIONS TIONS TIONS Rated Power Consumption ... 1650W. Microwave Output ... 1100W. Frequency ... 2,450MHz±50MHz. Power Supply ... 120V±12V, 60Hz. Rated Current ... -
Page 4: Circuit Diagram
WIRING COLOR O : ORANGE B K : BLACK : RED B L : BLUE W : WHITE Y : YELLOW - 2 - - 2 - Figure 1 Figure 1 Figure 1 Figure 1 Figure 1... - Page 5 4 . 4 . 4 . 4 . 4 . EXPLODED VIEW AND P EXPLODED VIEW AND P EXPLODED VIEW AND P EXPLODED VIEW AND PAR EXPLODED VIEW AND P CAVITY PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT.
- Page 6 SWITCHES AND MICROWAVE PARTS ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 411 082 5201 SCR TPG TRS 4 x 10 Z1 617 213 6936 H.V.
-
Page 7: Door Parts
DOOR PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 617 171 5026 Door Cover*** 617 199 5351 Door Panel***... -
Page 8: Control Panel Parts
CONTROL PANEL PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 617 222 1434 Control Sheet*** (Also order Touch Key Board when replacing Control Sheet) -
Page 9: Control Circuit Board
CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD (Part No. 617 221 5518 617 221 5518) 617 221 5518 617 221 5518 617 221 5518 3 4 7 0 0 3 4 7 0 0 3 4 7 0 0 3 4 7 0 0 3 4 7 0 0... - Page 10 CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD (Part No. 617 221 5518 617 221 5518 617 221 5518 617 221 5518 617 221 5518) Key No. Order Part No. Description INTEGRATED CIRCUIT. IC11 409 452 0901 IC LM8846-124FP...
- Page 11 5 . 5 . 5 . 5 . 5 . OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM - 9 -...
-
Page 12: Microwave Oven
(e) A microwave leakage check to verify compliance with the Federal performance standard should be performed on each oven prior to release to the owner. Micr Micr owave Oven owave Oven Micr Microwave Oven Micr owave Oven owave Oven Pr Pr Pr Pr Product Code No. oduct Code No. oduct Code No. - Page 13 If a microwave oven is found to operate with the door open, report to Dept. of Service, the manufacturer and CDRH* that...
- Page 14 SERVICE VICE VICE PERSONNEL. PERSONNEL. PERSONNEL. The SANYO service center should have the designated detector to measure the microwave energy leakage after the repair or adjustment. NOTE : Detector to be used at the service center is NOTE NOTE NOTE NOTE NARDA 8100, 8200 or the equivalent.
- Page 15 Rated Power Consumption .. 1650W. Microwave Output ... 1100W. Frequency ... 2,450MHz±50MHz. Power Supply ... 120V±12V, 60Hz. Rated Current ... 14.0 Amp. Safety Devices ... Thermal Fuse open at 332°F (167°C) for Cavity. Thermal Protector open at 252°F (122°C) for Magnetron. Fuse (Cartridge Type 20A) Primary Interlock Switch, Door Sensing Switch and...
- Page 16 • • • • - 3 - Figure 2 Figure 2 Figure 2 Figure 2 Figure 2 WIRING COLOR : BLACK : ORANGE : BLUE : WHITE : YELLOW : RED •...
-
Page 17: Test Procedures And Troubleshooting
6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING CAUTION CAUTION CAUTION CAUTION CAUTION - DISCONNECT THE POWER SUPPL - DISCONNECT THE POWER SUPPL - DISCONNECT THE POWER SUPPL - DISCONNECT THE POWER SUPPLY CORD FROM - DISCONNECT THE POWER SUPPL... -
Page 18: High-Voltage Capacitor
COMPONENT COMPONENT COMPONENT COMPONENT COMPONENT Measure the resistance : Across two terminals with an Ohm-Meter on highest scale. HIGH-VOLTAGE CAPACITOR including BLEEDER RESISTOR Ohm-Meter Ohm-Meter Ohm-Meter Ohm-Meter Ohm-Meter Measure the resistance : Across two terminals with an Ohm-Meter on R x 10,000 scale. HIGH-VOLTAGE DIODE Measure the voltage : Between test point TP-1,... - Page 19 COMPONENT COMPONENT COMPONENT COMPONENT COMPONENT Measure the resistance between terminals of FPC connector after removing it from S101. (Figure 9). TOUCH KEY BOARD - When reconnecting the FPC connector, make sure the holes on the connector are properly inserted in hooks of the plastic fastener in S101. TOTAL DEFROST PIZZA...
- Page 20 - 7 -...
- Page 21 - 8 -...
- Page 22 - 9 -...
- Page 23 - 10 -...
- Page 24 7 . 7 . 7 . 7 . 7 . DISASSEMBL DISASSEMBL DISASSEMBL DISASSEMBLY INSTRUCTIONS DISASSEMBL Y INSTRUCTIONS Y INSTRUCTIONS Y INSTRUCTIONS Y INSTRUCTIONS • • • • • OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL...
- Page 25 When removing the Magnetron from the Cavity or Wave Guide, use a proper care so that the dome of the Magnetron does not hit any adjacent parts of microwave oven. Make sure that the contact face of the Magnetron Gasket is free from any damage or deformation.
- Page 26 Remove the 20A Fuse with a screwdriver. NOTE NOTE NOTE NOTE NOTE When replacing the 20A Fuse, be sure to use an exact repair part. If the 20A Fuse blows immediately, check the Primary Interlock Switch, the Relay 2 (on the Control Circuit Board) and the Interlock Monitor Switch according to, “CHECKOUT PROCEDURE “CHECKOUT PROCEDURE...
-
Page 27: Removing Door
(1) Remove 2 hex nuts securing the upper hinge. (2) Tilt the top of the Door toward you. (3) Lift up the Door to remove it. NOTE NOTE NOTE NOTE NOTE - After replacing the Door, be sure to check that the Primary Interlock Switch, the Door Sensing Switch and the Interlock Monitor Switch operate normally. - Page 28 CAVITY PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 617 214 9189 Cabinet 411 082 5201 SCR TPG TRS 4 x 10 Z1...
- Page 29 SWITCHES AND MICROWAVE PARTS ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 411 082 5201 SCR TPG TRS 4 x 10 Z1 617 213 6936 H.V Transformer,*** N6T-P691 617 162 1945...
- Page 30 DOOR PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 617 207 0322 Door Cover*** 617 207 0360 Door Panel***...
- Page 31 CONTROL PANEL PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description 617 221 5235 Control Sheet*** (Also order Touch Key Board when replacing Control Sheet)
-
Page 32: Control Circuit Board
CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD (Part No. 617 220 2952 617 220 2952 617 220 2952 617 220 2952 617 220 2952) 3 2 9 0 0 3 2 9 0 0 3 2 9 0 0 3 2 9 0 0 3 2 9 0 0... - Page 33 (Part No. 617 220 2952 617 220 2952 617 220 2952) 617 220 2952 617 220 2952 Key No. Order Part No. Description INTEGRATED CIRCUIT. IC11 409 452 0901 IC LM8846-124FP TRANSISTORS. Q104 405 035 4809 2SC1685-Q-TP. Q101, 105 405 082 4609 DTA123YS-TP.
- Page 34 9 . 9 . 9 . 9 . 9 . OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM - 21 -...